Its in a recording studio and they need to be able to disable the ringer, flashing light ring would be nice but i dont think you can do that either on a 5402
You could try to use Ring delay on the user under the tlephony tab.
Ring Delay: Default = Blank (Use system setting), Range = 0 (use system setting) to 98 seconds, Software level = 3.2+.
This setting is used when any of the user's programmed appearance buttons is set to Delayed ringing. Calls received on that button will initially only alert visually. Audible alerting will only occur after the ring delay has expired.
___________________________________________
It works! Now if only I could remember what I did...
___________________________________________
The 1600 do silence and i thought the 54xx and not the 56xx to be honest
But i am not sure (can't test now)
Must be 4.2
ACA - Implement IP Office
ACS - Implement IP Office
ACA - Voice Services Management
______________
Women and cats can do as they please and men and dogs should relax and get used to the idea!
I noticed it on a 4.2 install (ip firmware 2.8.something!!). press the Vol Down and eventually the ringer goes off. not sure about 5610's. Going there today so might give it a go on them.
I like the fact that the date and time is displayed all the time on 4.2 5410's. Shame they didn't do it on 56xx's!!!
Jamie Green
ACA:Implement - IP Office
ACS:Implement - IP Office
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.