MikeAlturas
IS-IT--Management
thread940-1589079
thread940-1135892
thread940-909355
Sorry to resurrect an/some old threads. I hate when you search for something and cant find the answer, kinda like this XKCD Comic -
I searched on a few place and could not find how to do this. The old thread referenced the manual - and said there was no way to change the ringer. Well I read through it and there is a way. It's on page 20. "To select a ring pattern for your telephone: Ext + lift handset + #00 + Ext + *32 + ring ( 1-8) + #*00"
What I did was made sure the phone had Ext Ring -I / Ext Voice -I / SA Ring programmed to a button. Once programed just follow the instructions. Press the ext button and lift the handset, then press #00 and the telephone will make the beep beep program noise, then press the ext button again and press *32, from there you will see "Personal Ring" menu appear with Pat#1-Pat#8 if you cycle with the arrows. Select the ringer you want and press enter(on the phone). Then press #*00 to save and finish the programming.
I hope this helps someone down the road.... Today I was not DenverCoder9.
thread940-1135892
thread940-909355
Sorry to resurrect an/some old threads. I hate when you search for something and cant find the answer, kinda like this XKCD Comic -
I searched on a few place and could not find how to do this. The old thread referenced the manual - and said there was no way to change the ringer. Well I read through it and there is a way. It's on page 20. "To select a ring pattern for your telephone: Ext + lift handset + #00 + Ext + *32 + ring ( 1-8) + #*00"
What I did was made sure the phone had Ext Ring -I / Ext Voice -I / SA Ring programmed to a button. Once programed just follow the instructions. Press the ext button and lift the handset, then press #00 and the telephone will make the beep beep program noise, then press the ext button again and press *32, from there you will see "Personal Ring" menu appear with Pat#1-Pat#8 if you cycle with the arrows. Select the ringer you want and press enter(on the phone). Then press #*00 to save and finish the programming.
I hope this helps someone down the road.... Today I was not DenverCoder9.