3620 Problems

[gwildfire]

I have a 3620 router, I keep getting the follwing console message

00:07:06: ASSERTION FAILED: file "../src-36/quicc_lib.c", line 1213

This occurs a few times then I get this

%OIRINT: OIR Event has occurred oir_ctrl 1000 oir_stat CFCD


%OIRINT: OIR Event has occurred oir_ctrl 1000 oir_stat CFCC


%OIRINT: OIR Event has occurred oir_ctrl 1000 oir_stat CFCD


%OIRINT: OIR Event has occurred oir_ctrl 1000 oir_stat CFCC


%OIRINT: OIR Event has occurred oir_ctrl 1000 oir_stat CFCD


%OIRINT: OIR Event has occurred oir_ctrl 1000 oir_stat CFCC

This then shuts down s0/0

Show Ver

Cisco Internetwork Operating System Software
IOS (tm) 3600 Software (C3620-IK9S-M), Version 12.2(7b), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Tue 05-Mar-02 05:25 by pwade
Image text-base: 0x600089A8, data-base: 0x61314000

ROM: System Bootstrap, Version 11.1(7)AX [kuong (7)AX], EARLY DEPLOYMENT RELEASE
SOFTWARE (fc2)

3620_1 uptime is 8 minutes
System returned to ROM by reload
System image file is "flash:c3620.bin"

cisco 3620 (R4700) processor (revision 0x81) with 53248K/4096K bytes of memory.
Processor board ID 05599642
R4700 CPU at 80Mhz, Implementation 33, Rev 1.0
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
2 Ethernet/IEEE 802.3 interface(s)
1 Token Ring/IEEE 802.5 interface(s)
2 Serial network interface(s)
DRAM configuration is 32 bits wide with parity disabled.
16384K bytes of processor board System flash (Read/Write)

Configuration register is 0x210

The message comes up every 5-10 seconds
I have erased the startup and built from the beggingn.

 

[tecnikall]

Hello there,

The errors are generated by a malfunction in your power supply, which sometimes doesn't make a good contact with the motherboard power connector, leading to low voltage on the motherboard thus the voltage on the network module will be too low to operate. You will need to replace the power supply, as a work around you may remove the power connector and clean the motherboard contacts, however for the long run you will need to replace the power supply. Cheers and good luck

 

[gwildfire]

I tried swapping power supplied (I have 2 3620) and the fault remains on the origional so that didnt seem to make any difference, if I take it out of my 19" rack and reset it seems to run ok for a good while (40 mins) if I mount it again it goes within 10 mins could it be heat realted also?

Visit

http://www.Cisco-Engineer.com

for free Cisco rack access.

 

[tecnikall]

Hello there, as the router is getting hotter the power supply connection will become flackier thus the issue... If you have a hardware contract with Cisco you should be eligible for the replacement of the motherboard and the power supply unit. Cheers and good luck