Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
3600 not saving config after power down
- Thread starter vicbear13
- Start date
IllegalOperation
Technical User
You have to save the config in its NVRAM, assuming you are loading off of that. Do a "show startup config" to verify...
- Thread starter
- #3
- Thread starter
- #5
This may be a repeat message because my connection failed.
I checked and it was set at x02142. In the process of changing back to 0x2102, it hung up. Now NVRAM is corrupt. Displaying ASCII, Hex, etc. characters during boot. Cannot break and hangs during boot. This is via console port. W/O a flash card, is there another way to reconfigure this?
I checked and it was set at x02142. In the process of changing back to 0x2102, it hung up. Now NVRAM is corrupt. Displaying ASCII, Hex, etc. characters during boot. Cannot break and hangs during boot. This is via console port. W/O a flash card, is there another way to reconfigure this?
UmpaLumpa23
Technical User
Try connecting with differnet baud rates, go though all of them, it sounds like the config register was set to an odd setting.
- Thread starter
- #7
- Status
Similar threads
- Locked
- Helpful tip
- Locked
- Question