3550 Switch config problem

[thawk10]

I am a Newbe. I am attempting to configure a new 3500 series switch. I have all of it configured. However, when I do a "show run" command the interfaces all show "no ip address". Is there any way of getting rid of this. See the example below.

interface FastEthernet0/45
no ip address
spanning-tree portfast
!
interface FastEthernet0/46
no ip address
spanning-tree portfast

I have 12 other 3500 series swithes and none of them have this when looking at the "show run".

 

[IPKONFIG]

Try typing the "switchport" command at each interface.

"I can picture a world without war. A world without hate. A world without fear. And I can picture us attacking that world, because they'd never expect it."
- Jack Handey, Deep Thoughts

 

[vipergg]

Don't type it on each interface just use the interface range command to apply it to all interfaces at once . This also really depends on how you are using the switch ,are you routing with it or just switching .

 

[ADB100]

There is a global command to enable portfast by default on all ports so this is why you mabe don't have it in the interface config for the other switches:

spanning-tree bpdu-portfast default

I think that is the command. With this in global config all ports are portfast enabled so you may want to disable it on your uplinks.

Andy