Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

2948G L3 single VLAN Configuration

Status
Not open for further replies.
jward

jward

MIS
Dec 21, 2000
57
US
I setup a Cisco 2948G L3 switch with a single VLan configuration, When I migrated my server to is my backup
speeds went from 130mb transfer rate down to 6mb transfer rate. I'm still lost when configuring this switch so any information would be helpful.
 
Sort by date Sort by votes
Set your sw port speeds to 100 Full Duplex and force the same settings on the server, if you look at your switch port, it's probably generating a lot of errors...

Any servers running on your switches should always have their nic's forced to max speed the switches support...

Mike J
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

telemarksman
  • Locked
  • Question
ATA Cisco SPA122 not triggering single line courtesy phone ringer
Replies
0
Views
252
telemarksman
telemarksman
cheikhdtn
  • Locked
  • Question
VLAN
Replies
3
Views
269
iggsterman
iggsterman
DrB0b
  • Locked
  • Question
Known issues or dangers in purchasing L3 switches that are used
Replies
3
Views
318
CASSBusinessSystems
CASSBusinessSystems
Tariq Habaybeh
  • Locked
  • Question
Cisco 881WD-E-K9 router configuration
Replies
1
Views
277
burtsbees
burtsbees
DrB0b
  • Locked
  • Question
Cisco SG300-28PP PoE Switch issue enabling L3
Replies
2
Views
376
CASSBusinessSystems
CASSBusinessSystems

Part and Inventory Search

Sponsor

Back
Top