Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

2811 T1 setup

Status
Not open for further replies.
blubomber

blubomber

MIS
Joined
Dec 27, 2001
Messages
241
Location
US
I have a 2811 router with a T1 WIC II card in it connected to a Point to Point T1 line. Only data will be going across this T1 line, no voice. What is the proper way to setup the serial interface as far as timeslots and stuff goes?

Thank you for any help.
 
Sort by date Sort by votes
If it is full T then most likely only need to set
encapsulation to PPP on both ends and service-module t1 clock source internal on only one of the routers. Also IP address info for both interfaces. Default for T1 card uses all of the 24 time slots and B8ZS ESF coding.
 
Upvote 0 Downvote
Great, that is what i needed to know. Yes it is a full T1. Thanks again for your guidance JOAMON!
 
Upvote 0 Downvote
Make sure to double check with the service provider for which encap and line coding they need you to use.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

inlsp05
  • Locked
  • Question Question
2811&2960 48 volts wiring diagram
Replies
1
Views
621
BOKA
BOKA
inlsp05
  • Locked
  • Question Question
2811 ios start with cf
Replies
0
Views
340
inlsp05
inlsp05
Zia khan
  • Locked
  • Question Question
Cisco: 2811 Router
Replies
1
Views
347
CASSBusinessSystems
CASSBusinessSystems
kjhg
  • Locked
  • Question Question
2811 ROUTER
Replies
3
Views
457
iggsterman
iggsterman
AccidentalAvayaAdmin
  • Locked
  • Question Question
Cisco 2811 buffer leak
Replies
0
Views
250
AccidentalAvayaAdmin
AccidentalAvayaAdmin

Part and Inventory Search

Sponsor

Back
Top