Hey cisco gurus,
Senerio:
I configured the 2950 switch with vlans 10-50. The fa0/1 is set for trunking. Also I have set all the 24 ports to different Vlans that corresponds to the VLAN settings on the 2621.
The trunk is connected to 2621 Fas0/0 and its sub interface fas0/0.1 set to "encap dot1Q". I have fas0/.01-0.6 set up for VLANS 10-50 with "nat inside" and also set the "ip helper-address xxx.yyy.zzz.ddd". For Fas0/1, I assigned an Ip address to it with "nat outside" & "no shut" command.
I have a DHCP server connected to fa0/2 on the 2950 and a workstation conncted to (fa0/5;VLAN 20) and (fa0/10;VLAN 40). I am able to get the correct DHCP address relative to the VLANs my workstations reside on. ALL is great.
Any suggestions/HELP?
What I would like to do now is to connect my 2621 router to the linksys firewall via Fas0/1 and allow my work stations on the diff. VLANS to access the interet and not allow internet access depending on what VLAN the workstations reside on.
I have some ideas of how I might be able to do this, but I am not sure of IOS command sets. Has anyone accomplised this?
And can anyone post up the startup-config for this kind of setup?.
Any suggestions would be greatly appreciated.
Thanks,
rtfm2003
Senerio:
I configured the 2950 switch with vlans 10-50. The fa0/1 is set for trunking. Also I have set all the 24 ports to different Vlans that corresponds to the VLAN settings on the 2621.
The trunk is connected to 2621 Fas0/0 and its sub interface fas0/0.1 set to "encap dot1Q". I have fas0/.01-0.6 set up for VLANS 10-50 with "nat inside" and also set the "ip helper-address xxx.yyy.zzz.ddd". For Fas0/1, I assigned an Ip address to it with "nat outside" & "no shut" command.
I have a DHCP server connected to fa0/2 on the 2950 and a workstation conncted to (fa0/5;VLAN 20) and (fa0/10;VLAN 40). I am able to get the correct DHCP address relative to the VLANs my workstations reside on. ALL is great.
Any suggestions/HELP?
What I would like to do now is to connect my 2621 router to the linksys firewall via Fas0/1 and allow my work stations on the diff. VLANS to access the interet and not allow internet access depending on what VLAN the workstations reside on.
I have some ideas of how I might be able to do this, but I am not sure of IOS command sets. Has anyone accomplised this?
And can anyone post up the startup-config for this kind of setup?.
Any suggestions would be greatly appreciated.
Thanks,
rtfm2003