ethereal112
Technical User
Can anyone send me a copy of system message 33-S. I've had this alarm on my switch and dont have the manual to break it down, If better is there a website where I can view the manual online?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
2400 IPX sys.ops & maint. manual
- Thread starter ethereal112
- Start date
- Status
OzzieGeorge
Programmer
belevedere
Instructor
33 S is an IP Package failure. Either for IP trunks or the IP PAD card. Additional information on the alarm list out will tell you the location of the card and the reason for the fault.
- Thread starter
- #4
ethereal112
Technical User
Thanks for the link OzzieGeorge.
Belevedere
I got the alarm message but what the problem is is that we have all IP cards in PIMs 020-021XXX and my alarm is giving me MG 0 Unit 0 Group 18 no level, It doesnt make sense since there are no IP Stations in this slot. As far IP stations go they are all programmed in the virtual PIM 030XXX-033XXX. I got so frustrated with the alarm I removed the ELC card that was programmed in that slot to see if that would clear up the alarm, but no luck.
Belevedere
I got the alarm message but what the problem is is that we have all IP cards in PIMs 020-021XXX and my alarm is giving me MG 0 Unit 0 Group 18 no level, It doesnt make sense since there are no IP Stations in this slot. As far IP stations go they are all programmed in the virtual PIM 030XXX-033XXX. I got so frustrated with the alarm I removed the ELC card that was programmed in that slot to see if that would clear up the alarm, but no luck.
- Status
Similar threads
- Locked
- Question
