Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
1220 IP Phone
- Thread starter Qwiksting
- Start date
Yes. Sequence below applies to 12xx/11xx/2007. It does NOT apply to 2001/2002/2004.
With UNIStim software release 3.0, and greater, the following keypad sequence is used to reset all provisioning parameters to a “factory default”:
[*][*][7][3][6][3][9][MAC][#][#]
Where MAC corresponds to the MAC address of the IP Deskphone which can be found on a label on the back of the IP Deskphone.
Since a MAC address can contain the letters A through F, the letters A, B and C can be entered via the [2] key on the dialpad, and letters D, E and F can be entered via the [3] key.
For example, an IP Deskphone with MAC address 00:19:E1:E2:17:12 would be reset to “factory default” when the sequence **73639001931321712## is entered on the keypad.
Please note that the keypad sequence will only be accepted by the phone after the IP Deskphone has finished its boot-up procedure.
With UNIStim software release 3.0, and greater, the following keypad sequence is used to reset all provisioning parameters to a “factory default”:
[*][*][7][3][6][3][9][MAC][#][#]
Where MAC corresponds to the MAC address of the IP Deskphone which can be found on a label on the back of the IP Deskphone.
Since a MAC address can contain the letters A through F, the letters A, B and C can be entered via the [2] key on the dialpad, and letters D, E and F can be entered via the [3] key.
For example, an IP Deskphone with MAC address 00:19:E1:E2:17:12 would be reset to “factory default” when the sequence **73639001931321712## is entered on the keypad.
Please note that the keypad sequence will only be accepted by the phone after the IP Deskphone has finished its boot-up procedure.
- Status
Similar threads
