0x32 Rls 4.1 Call Forward

[jbenpeter]

Is there a way Call Forward outside the system using Feature 4 like the BCM. The only way I can impliment this is to use Line redirection.

 

[hawks]

Build a Rout and Desti code then turn on allow redirect for the phone. Then you should be able to do it.

 

[jbenpeter]

The route was built before thats how it was set up. At the Forward TO after F4 I get a invalaid number. It only alloows me to put in Internal Extentions.

In the documention is specfically stats use Line Redirection for call going outside the system.

 

[lugerlover]

if you realy have 4.1 then invoke routing..allow redirect in set programing and then u will be able to forward example 9-1-800-555-1212 and only if you ahve met the above criteria

 

[shipwright]

http://www.tek-tips.com/faqs.cfm?fid=2078

 

[jbenpeter]

Routing is set for route 001 use line pool A, Dest code is 9 normal and absorb length all. Redirect is set to yes but I still get in the "invalid number". I just don't want to call nortel for just a simple problem and the book says to use call redirection. But just a simple featue I think that nortel would impliment this in software rls 4.1.

 

[lugerlover]

what version of software is it..what is sp version

 

[jbenpeter]

Soft Rls 4.1

 

[lugerlover]

where you using line pool codes /access code of 9 before...must remove for routing to work

 

[jbenpeter]

If I was using 9 as an access code to a line pool it would not allow me input 9 as a destination code in routing, so routing is fine. I know there is one person out there who can get their hands on a 0x32 rls 4.1 to verify I think it does not work. Line redirection is the only way in that version software.

 

[lugerlover]

it works fine..there is something you are missing

 

[lugerlover]

just for hell of it ..what is your sp version

 

[jbenpeter]

SP 30NdG04 NAT

 

[covcom]

I would try a different dest. code

 

[jbenpeter]

Went to the customer site to verify software release and like I innitially thought its a 4.0 rls. Should have done this from the start never trust the customer.