Search results for query: *

I have a PIX515E that has only one server behind it. There is very little traffic to/from this server. However the PIX will only allow traffic to pass through it for about 10 minutes. I then have to connect to the PIX and perform a "Reload" - it is then ok again for another 10 minutes or so. I...

Hi, Still having the same problem with no success in resolving yet. I have count figures from just before the units stop passing traffic... nmpix# sh conn count 9 in use, 13 most used nmpix# sh xlate count 7 in use, 18 most used Are these figures too high?

The 10-minute timeout occurs regardless of which unit is currently active. I've never tried using the FO PIX as a standalone unit for precisely the reason you mention (though I seem to recall reading the reboot period is every 24 hours.)

(Primary) show ver Cisco PIX Firewall Version 6.3(1) Cisco PIX Device Manager Version 3.0(1) Compiled on Wed 19-Mar-03 11:49 by morlee nmpix up 4 hours 55 mins Hardware: PIX-515E, 64 MB RAM, CPU Pentium II 433 MHz Flash E28F128J3 @ 0x300, 16MB BIOS Flash AM29F400B @ 0xfffd8000, 32KB...

sorry, I should have specified - that is from the console and is the count AFTER I can longer send/receive. Gerrard

nmpix# show conn count 0 in use, 1 most used nmpix# show xlate count 0 in use, 2 most used Don't think this is the problem...

Help please? I've spent the best part of a week trying to discover why our pix 515e-UR-FO bundle stops allowing traffic in or out after approximately 10 minutes uptime. If I issue the "reload" command, or switch the power off to the Active unit everything starts working again for about 10...