Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. cwarren

    Cisco VOIP versus Avaya VOIP

    Guys, this forum should be for us all to share our comments and concerns, but this is ridiculous. People are cutting and pasting messages from other forums and talking about financial success..... We all have our opinions about these two companies, but just answer the person's question. These...
  2. cwarren

    VOIP Solution?

    YOu do need to get the NM-HDV module. The VWIC cards go inside of this. You would then need a VWIC-1MFT-T1. Connect this to a DS1 card on your G3. You will also need a 356A adapter for the PBX. This is an 8 port adapter that you will use to connect the router to the PBX. Use port # 8. Hope...
  3. cwarren

    G3 CDR Devices ?

    Nevermind..I wasn't thinking You have to set the secondary output to go to the data module extension. Then bring up hyperterm and capture the text.
  4. cwarren

    G3 CDR Devices ?

    Ok, but then do you have to go into the cdr form and for the second output (I think that is what it says), put the extension of the data module? Or else, how does the switch know to send data to that station port?
  5. cwarren

    G3 CDR Devices ?

    What if you have no serial connection to use. I know there is a way that you can connect to a station port to collect raw data using hyperterm.
  6. cwarren

    G3 CDR Devices ?

    filakio---Can you give me some more info on connecting devices using the TN754 circuit pack. We too have no open ports to use. Thanks Chris cpwarren@renlearn.com
  7. cwarren

    Connecting Definity G3 to Cisco AVVID System

    fastbusy, I think we got it working pretty good. There wasn't too much config on the G3. Chris
  8. cwarren

    VOIP Solution?

    We've done it using a 2600 router. ds1 board config robbed-bit, esf, b8zs, leave the defaults trunk group wink/wink with defaults cisco router e&m wink start on the T1 controller Ours works pretty well, just trying to figure out the best way to integrate Definity Audix. Chris
  9. cwarren

    ArcServe 6.5 starts at the wrong time

    Has anyone else experienced this...... Ever since the time change for daylight savings Arcserve starts the backup jobs an hour late. The server is set to the proper time and the proper time zone (GMT -6:00 Central). The Activity log shows that it starts an hour late, but if I look at the job...
  10. cwarren

    Connecting Definity G3 to Cisco AVVID System

    Has anyone combined these two? Does anyone have any advice? We are trying to figure out the best way to do this. We will have another location where we are going to install the Cisco AVVID system. We would like to connect it to the Definity G3 system at our main location and have 4 digit...
  11. cwarren

    More Linking to PBXs

    Can anyone help with this? We are trying to link two PBXs together. They are currently linked with ds1 boards wich run to Paradyne CSU/DSUs which then connect over a T1. We are going to be using an IP over SONET connection to connect the two sites in the near future and would like to get rid...

Part and Inventory Search

Back
Top