Search results for query: *

I have been getting the same error. It just started showing up when our RA8000's were upgraded by Compaq. Not sure the solution yet..

Simply use a blank host header so IIS answers for all IPs..

It may be a reverse NATing issue. Try accessing the site with the internal IP. If this works try setting up a internal DNS or maintain a global hosts file that your workstations can use..

I guess this anwsers the question but you should never plug any equipment directly into a wall outlet without some protection (surge/spike).. Anyone else have experiences with this? Thanks..

My company has @25 NT servers which most are being protected by a large APC Symmetra UPS. I am reviewing the current setup and working on some recommendations. Most of our servers have 2 or 3 power supplies, it is my understanding that these are only for redundancy and not load balancing (Compaq...

Sorry J.Fisher but you stated this to my questions some time ago and although I do not know the exact reason for this it is true that you will not be able to ping the serial interface in some cases. In an example I have setup a frame-relay network and while fully funtional I have never been able...

Thanks Humby (MIS)... Just what I was looking for!!

Can anyone tell if it is possible to setup a router with one phyical frame-relay connection and multiple logical connectioins (sub-interfaces) where the total bandwidth of all the remote Frame Relay connections add up to more then the total bandwidth of the main Frame Relay connection. In other...

The PVC I have configured is listed as "Active" but my real question here is "Shouldn't I be able to ping the serial0/0 interface IP (141.155.127.93) from the router's CLI if the serial0/0 Line is UP and protocol is UP (SHOW INT)? Verizon is the tele company and we have had...

Protocol: TCP/IP Tried ping a hundred times.. Pinging Serial0/0 while logged in on the router through Eth0/0 interface. Thanks, Robin

I am setting up a Cisco 26xx with one Ethernet and one T1 CSU/DSU WAN module. I have included the interface config below but what I can not understand is that I cannot ping the IP of the interface even though the Line and protocol are UP. There may be some issues with the PVC and or ISP but...

I am setting up a Cisco 26xx with one Ethernet and one T1 CSU/DSU WAN module. I have included the interface config below but what I can not understand is that I cannot ping the IP of the interface even though the Line and protocol are UP. There may be some issues with the PVC and or ISP but...