Search results for query: *

hi, when booting our alteon eb1639113 accelerator is comes up with ERROR: Softdog driver open failure switch still boots and runs ok anyone seen this and know how to cure it? also how do you set the clock?

hi, does anyone know how to recover the password on a nortel contivity 251 (dm1401096) ?

hi, switches dont reboot phones reboot irratically, i ve only ever seen 1 at a time do it, on a working system that works for a few days then sends a port into reset after that its ok for a bit

hi, we are experiencing a lot of issues with these switches resetting ip phones intermitantly, switch is hareware version 6 with software version 3.1.7.08, it doesnt seem to make a difference how many phones we have on the systems from just a few to all 24 they just seem to reset. anyone...

hi to all!, how do you factory reset this card?

hi does anyone know how to make a contivity 1750 recovery disk? i have a good unit i can access and several with passwords set i need to recover, and it looks like you need a disk to do it!

hi, just got some 1750's but they all are passworded any one know how to overcome this other than sending back to nortel?

hi to all, i have a 3524 that has lost its software but it says i cant do an xmodem recovery because the unit has also lost its mac address does anyone know how to put it in again? thanks.

hi, we are trying to set up 2 of these routers in back to back configuration, does any one know what has to be configured to purely send data from the lan port over the hssi port to a pc attached to the lan port of the remote router, there are about a billion commands but all i have to prove is...

hi, our argent branch just sits on my bench flashing its lights at me looking all sad, in manager it shows no MAC or IP address when trying to bootp, DTE port isn't doing much either, any one know a work around or is it bin time?

hi i need to upgrade a 403 is there any pitfalls in jumping from 1.2(14) to 2.1(15) as this seems to be the only disc i have! thanks

hi, im trying to remove the password on an old argent branch, i have tried the prodedure in the FAQ section using the dte port but it looks like the at commands only work on ip offices's i have the old argent software discs (2.2(65) and it wont let me reset the unit via that without the password...

hi, we are just upgrading from basic rate to primary rate on our incoming lines, is it just a case of swapping modules in our ip 403 or will it need a lot of programming? we are only having 8 of the 30 channels lived up to match what we currently have thanks in advance for any help

hi, im trying to reload the software onto a phone 8, it is not seen by the ipo and when i connect to the dte port all i get is "tftp poll fail" anyone know how to force the software on?