Search results for query: *

Glad to see that someone is at least getting some proactive response with Comcast. I haven't. We know that Comcast is definitely holding most of the guilt with this, but is this also a possible ASA software load issue as well? I can confirm with the IT guys what load they are running as well...

Just another two cents to throw in. This must be a recent Comcast change within their infrastructure because I've had Comcast in my office for years and all of the remote VPN phones I've configured over the years and tested, have been in the office and connecting to the customer sites prior to...

Well, It's good to know that I'm not the only one having the same Comcast issues - however it's not good that everyone else is having the same issue. We're having the same results with the Cisco ASA where the tunnel builds and authenticates like a charm, but the phone just sits there looking...

Recently had three 9620L VPN phones (out of a total of 5) that stop responding - getting the discover IP message on the phones, when the remote clients changed their network from Century Link to Comcast. As it turns out this seems to be a Comcast network concern because I can duplicate the same...

Well, this has turned out to be a big pain. I've followed the Avaya technical tips doc to the note - created and deleted several users. It all seems pretty straight forward, however no go. I can't get past the initial IKE exchange. I've created a user, however my telnet access shows no...

No, I've found reference to Sonicwall and Juniper but nothing for the Adtran. I'll certainly give this a try. Even the knowledgebase doesn't seem to have anything - unless i simply didn't look in the right spot. I'm working on getting this completed or at least working today. I'll respond...

We recently upgraded a customer's Kentrox Q2200 to the Adtran 3430 to support bonded T1's. All existing configs are working fine, however I can't get the 5610 VPN phones to communicate with the router. I've had this working great with the Kentrox but can't seem to get past the IKE no response...

In response to Mike's question, for no apparent reason the phones aren't able to pull up dialtone/intercom from the IPO. Sometimes just turning off the base unit will remedy the problem. Just yesterday the four phones using the lines from base 00 simply stopped getting a line. The two way...

We have an IP500 ver 4.0.10 with one digital 8 module(6 - 5410 sets) and two analog modules for a total of 16 portable sets. This setup is running the Engenius Durafon Pro's for a rural campus environment with four base units - dedicated extn's. We are constantly having trouble with the...

I have a new customer that has a Magix at site A and an IPO 500 at site B. Calls can be made across the grid to both sides without problems. We would like to set up some way to have calls parked on the Magix and to be able to retrieved by the IPO users. All lines are in the Magix, so all...

Avaya says that it can't be done, however has anyone tried to use the call monitor/listen to a hunt group member from one site to another? We have three 406v2's in SCN. Site A wants to monitor agents at site B and C. I don't want to resort to using Phone manager Pro IP if I can avoid it...

We're trying to setup 3 IPO's over ADSL using the Prestige 642r routers and the Avaya vsu 5. Any known problems with this config - cost is an issue, and the usage will be minimal at best. We have static addressing for the WAN side at all sites.