Search results for query: *

Will check the PHY1STAT settings. Firmware is still on 1.1 which is the same as phones on our other sites which work fine with no errors

Will double check that as well..I know the phones are running at 100Mb full and was informed by networks that they were set to 100Mb full as well. Yes we are using seperate Vlans for the Data and voice

There's no Duplicated Registered IP Station address's but will check with networks for anything further.. the S8300B is on HW04, FW001

Hi All I'm having intermittent problems with users on a S8300, G350 setup where a users phone will ring but there is no display information and no flashing button next to the main line to indicate a call. The call cannot be answered on that phone. Sometimes the display will start working after...

thanks..all done

Hi all Whats the setting to change DTMF tones on automatically when connected to a external ISDN trunk ie instead of selecting the ETE soft key... thanks in advance

thanks

Hi all Does anyone know of a source of replacement batteries for DT570 and DT368 Dect Sets? Also anyone who repairs DT570/ DT368 phones A/B phones. I know these are getting old and we've been told there's no replacement models now only GAP type. thanks

You'll need to lookup the RO commands.. BASIC EXCHANGE Operation and Maintenance ACS Route Data ROCAP RODAP ROEDP etc..... You may also want to check the OP commands to see if any operator Traffic groups are assigned etc...

Hi there Has anyone upgraded the HDD on a Sony PCG-Z600 TEK laptop before? I'm looking at upgrading the current 20Gb to 60Gb.. Also does anyone have instructions for the dis-assembly of the laptop... thanks in advance

Hi there Has anyone upgraded the HDD on a Sony PCG-Z600 TEK laptop before? I'm looking at upgrading the current 20Gb to 60Gb.. Also does anyone have instructions for the dis-assembly of the laptop... thanks in advance

What's your email address and I'll send you a Tracker User guide....

To close out of a Tracker session.... ;ESC (This breaks the connection to the serial port to the switch) ;QT (This drops the Tracker connection) Make sure it's in Capitals..... Good Luck

Thanks again Patcher....Was able to restart after hours and it's all ok now..What is the process if required to be done during working hours?

To Patcher The software revision is BC11 SP8, What information is missing from the SUSIP? To ecptfa I've restarted the tlp50 unit in Lim 7 and restarted KLP1 units and bpos 7-2-62. The fault still remains. You can relocate the extn to a different equipment position then do a CTCOP on the...

Hi all I have a problem where a extn always shows a connection towards a trunk cct. This only shows from a call trace or SYECP but doesn't show busy via a SUSIP. The extension user can't receive calls or initiate calls. <SUSIP:DIR=3401; STATUS INFORMATION AT 11:30:54 06JAN03 DIR TYPE TRAFFIC...

thanks for that patcher...

Hi all I have a problem with the clocking on a remote site's group switch. The following errors show; <ALLOP; DATE: 30DEC02 TIME: 12:18:19 CLASS: 3 88 GROUP SWITCH MODULE CLOCK ALARM DATE TIME ALP NOIF GSSIDE GSM 22DEC02 16:48:44 2 1 0 0 END <GJLOP...

Thanks for your replies, much appreciated. Will go with the FIDIE command after discussions with the customer.

Hi all I'm after advice based on some system alarms. Basically the Alarm 108 appears showing less than 5% free space on the Hard disc subfile system. I believe that it's due to the traffic reporting. See prints below; <ALLOP; CLASS: 3 108 FILE SYSTEM ROUTINE TEST ERROR DATE TIME ALP...