Search results for query: *

What phone do you have, SLT or APT? For SLT phone you need to set 628 SLT Caller ID / Enable

It is the last version

It was sent!

https://drive.google.com/drive/folders/1z-K1U4S1r8fKMr7hP_uG5oGmrA970U9V?usp=sharing

You need to create rules on Mikrotik/Firewall Signaling ports 2427, 2727 and 9300 forward to IP adress of IPC MPR RTP (Voice) ports 8000-12000 forward to IP adress of DSP

I have a one unused NCS3716 (16 SIP ext) key for NCP

If you activate HEADPHONE MODE on the phone (PROG / 61/ ON), the message will be played on the Headphone port. Then make a audio cable adaptor 2,5mm to 3,5 mm and connect into audio input of your PC. Us some audio recorder app , start recording and start playing OGM

Should have done, you can add 3 pcs 24-port cards. TDA0105 is not for TDE :unsure:

How many EXT cards do you have and which ones? I'll try it on our model.

TDE200 with PWR-L supprots 168 EXT (w/o DHDP) 8 EXT cards, but max 5 MSLC24

WAV file format saved in KX-NS PBX is as follows. G.711 , Mu-law , 8bit , Mono

What does "Error log" say ?

DSP determines the number of simultaneous connections, which depends on the codec, the connection between the SIP phone and the DPT/APT, and the SIP lines. Read the Feature manuals

You have four Ring tones for DPT

In attachment If you use DISA numbers 1-4, set other numbers ( 0, 5-9 ) on the operator or on an empty DPT or DXDPT port ( for disconnect call)

Attached are a few examples of h323 connections. In a Maintenance Console you have IP-GW16 protocol trace, that way you can monitor and compare both connections, what is missing. Of course you also have a VoIP voice test Tool. Check default signal ports on both side , Shelf Properity-Vitual...

Instructions attached

To begih with, pull all the cards out, a couple of cm ( LCOT, EXT, OPB), leave only PWR and MPR If the MPR is going up , review the list of errors , then return one by one card to the slot (you don't have to shutdown the PBX). If the MPR does not up , try replacing the PWR or MPR, very rarely...

When connecting 2 PBXs, set the 8290 to "Private" mode (Q-sig Master or Slave) and you have to replace the receiving and transmitting wire pairs. And you also need to have two numbering plans ( Other PBX). If there are free slots, it may be simpler to use the TDA0290 card, which you can...

what model HV do you have?