Search results for query: *

The phone system V4 is older than the OpenStage phones - therefore you have to put the phone into OptiPoint mode instead of just plugging it in as OpenStage.

I would use www.remoteutilities.com instead - but that's just me - 10 free licences

The phone system will be older than the phone so Hold down the menu key and pick 'OptiPoint' mode, then save and restart the phone. Keymap will have to be 'worked out'

Those were release for V6 if I remember correctly

That looks good lisluk - many thanks - I'll try it out as soon as I can and let you know

Thank you very much Lisluk - I can try that Would you know then how to 'set the customer lan ip address' / gateway / subnet mask ?! Maybe I can just try that - the ./ will probably allow me to set it ?

Hi Masviss. There were commands that could be input to set the customer lan ip addres - I had the info and used it on early versions on UW7. It was one way to access UW7 without the Browser. The info I had was a 'few laptops ago' when there were no cloud backups and hdd's went in service. Thanks.

How do I set the Customer LAN IP address using the Comwin only - command STA-UW7; - logging on there - as far as I remember there was a way to input the customer LAN IP address/Subnet etc. there using that and not the Assistant

This MAY or MAY NOT Work but give it a try. CHA-SBCSU:STNO=3010,CALLOG=ALL; CHA-SBCSU:STNO=3011CALLOG=ALL; CHA-SBCSU:STNO=3012CALLOG=ALL; CHA-SBCSU:STNO=3013,CALLOG=ALL; Also the other Extensions 3004 && 3009 need it turned on as well

OK - if your HiPath 4000 was just 'reset' then can you please tell what is on the little screens when you press the 'Display On' button - thanks.

Are you looking to log on to the system ?

Indeed, all TDM phones should be updated anyway using the TSDM tool within the V11 Assistant

Not sure what you mean but CP200T/405T - Minimum OS4K Version V8 R2.22.24 includes CP200T and 205T Best is to try out the phone - plug it in and test

CP200T/405T - Minimum OS4K Version V8 R2.22.24

SIP and HFA firmware for phones at https://www.tek-tips.com/forums/965/faqs/7883

The correct forum on here is called Siemens Hicom Here is the link to that forum: https://www.tek-tips.com/forums/siemens-hicom.965/ And the link to the FAQ about software etc. for phones: https://www.tek-tips.com/forums/965/faqs/7883

I don't know much about the OSB but I think that a larger PABX like OpenScape 4000 or OpenScape Voice would do that work easily.

Try your question in the Hicom Forum https://www.tek-tips.com/forums/siemens-hicom.965/

That's normally for trunk groups - Priority is decided in the BUEND AMO and then you assign that priority to a key. But for end users I think that it might need MLPP (Multi Level Precedence and Protection) - you tell the phone in SDAT what it's level is and you set it up in ZAND and ACSU AMO's -...

There should be an NTP Server (Network Time Protocol) on the local area network