Search results for query: *

Hi, Yeah - follow huntgroups, and twin when logged out are both ticked. And I have enough licenses.

Hi, thanks for the reply. I've set the ring mode to Collective - and it is only twinning out to one of the phones... Mike

Hi, Is it possible to setup mobile twinning to more than one destination? Example - I have a hotline number, I would like to twin out to two different cellphones. Thanks, Mike

Hmm.. ok - I will have a look at that.. thanks

For out bound traffic from my network to a /23 network? thanks, Mike

Thank you for your answer. Basically I have 2 IP transit suppliers (announcing all routes) - However for network X.X.X.X/23 I want to use one specific IP transit.. Does it make sense? thanks, Mike

Hi, I have a couple of 3560s - on which I am running BGP between (loopback) and up against two different peers. I would like to inject a route for a specific network... Fx. I would like to route all traffic for a specific network to one of the peers. How can this be done? Many thanks, Mike

Hi, I have an IPO500v2 with several SIP trunks and DIDs from different countries ( I have set locale for the incoming call route) However, queueing announcements are played in the system language... any chance I can change this to the locale of the incoming call? Many thanks,

Hi, Yes, I am familiar with this approach - though I was looking for a completely automated solution. Any ideas? thanks, Mike

Hi, I've enabled EC500 on my CM6 system and everything works great.. The called is twinned out etc etc .. One of my users would like for the call to be twinned only during office hours - after 7pm (and the weekends) she would like for the EC500 to be disabled. I'am aware that she could...

OK thanks

OK. So best effort, would be to increase TCP_KEEP_ALIVE_TIME and TCP_KEEP_ALIVE_INTERVAL to higher values - then the delay before reboot would be greater.

Thanks for the answers. The network issue has been dealt with - and this does not happen often. But fx- recently (last night) I had some packet-loss on my server-side (callserver) - and all telephones unregistered and rebooted. Looking at smokeping/mrtg for all links both server and CPE side...

Yeah - I can see the TCP KEEP-ALIVES settings.. might be worth tweaking them - not sure it is the culprit though.. Per default - it sends keep-alives every 60 seconds - and if it fails, it will re-transmit every 10 seconds.. though it doesn't say, how many times it will re-transmit - and what...

Thanks for your reply.. Well - as I read it, the QoS settings will only generate an alarm, it should not provoke a restart?? My L2L VPN - is standard Cisco stuff - and yes, I send keep-alives. Thanks,

Hi, I have several 1616's and 1608's connecting to a call server (IPO500v2) through site-to-site VPN. Whenever we see a little packetloss on the line (>2%) - the phones restarte/re-register. Is there a way I can tweak the threshold / tolerance of the phone registration - so even if it loses...

OK - will try to set all to 00:00 Cisco Adaptive Security Appliance Software Version 8.2(2) Thanks

I've added the reverse-route to the crypto map - perhaps that will help?

I have everything turned off. Except for: Connection: 03:00:00 Translation Slot: 06:00:00 None of it matches the 4 day reboot. Actually the phone will reboot exactly after 4 days, even if I am in the middle of a call!! Mike

The following has been configured on the ASA: crypto dynamic-map SYSTEM_DEFAULT_CRYPTO_MAP 65535 set security-association lifetime seconds 2147482800 crypto dynamic-map SYSTEM_DEFAULT_CRYPTO_MAP 65535 set security-association lifetime kilobytes 2147483647 Mike