Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. trav87

    Nortel 6140 WLAN Handsets continue to ring

    We have a couple 6140's setup as the same extension as desk phones for employees who are away from their desk often. If a call gets picked up at the desk, the 6140 will continue to ring untill you hit the end button. Then the phone resets itself. Anyone run into this problem? CS100 Rel 6.0...
  2. trav87

    Rls 7.0 Bugs

    The 8 digit name problem is the same in release 6 for 500 sets
  3. trav87

    ELAN IP change

    NN43001-260 is what I have found so far for changing IP's, and it seems to be a different version of the .pdf our vendor had. It references NN43001-315, but I had trouble finding a release 6.0 copy. How the heck can I get 10,000 results searching for NN43001-260 on avaya's site?
  4. trav87

    ELAN IP change

    UCM - Yes We can't even ping pbx to Signaling server, so we cant redistribute the security token, nor rejoin the security domain. The Call Pilot server pings both, and I can ping everything from my desktop PC. Our vendor has a ticket open with Avaya, but due to schedule conflicts, won't be...
  5. trav87

    ELAN IP change

    We have a CS1000 6.0 with Call Pilot 5.0 and IBM secutiry servers. Our infinately wise IS team has decided that we need to change one octet in our ELAN IP addresses. We can change the ELAN on the switch and CallPilot, but once we get to the security servers and change IP info in...
  6. trav87

    CS1000 Succession 5.0 all analog sets no ring signal

    Yep, this is the same exact problem I had with a 3.0 61, I pulled the sys mon card and the issue cleared but a new card did the same thing and I had to replace the PDU unit in the pedestal. Wasn't bad, power off column and finished in 10 -15 minutes " I am going through the same thing right now...
  7. trav87

    Toner and Probe kit for active PoE cables

    I would look into a tester/analyzer that has the ability to flash the LED's on a switch. At my work, there was never any documentation or standardized labeling in the past, now I have a nightmare to try and straighten out. I have a Ideal cable certifier that will blink the switch port LED on a...
  8. trav87

    cat6 patch panel

    3 to 4 48 panels an 8 hour shift should be an easy job for 1 person, including seperating and dressing.
  9. trav87

    Grounding Question Continued...

    You should be fine with running your ground back to the secondary panel grounding bus. That secondary panel is what's distributing power to your outlets in the standalone building, so by grounding to that panel you are removing any potential ground difference.
  10. trav87

    AUD035 and AUD038 Messages

    Still not sure what he did, but the AUD035 & 038 messages are back.
  11. trav87

    AUD035 and AUD038 Messages

    I had the same AUD035 and AUD038 messages scrolling last week. We are in the middle of changing IP's on our Phone system and lost connection to our TM server. The tech who cleared the messages did the work while I was offstie so I don't know what steps he took. I will ask him next week when...
  12. trav87

    USA: If you missed the change from Daylight to to Standard Time

    Thanks, that was it
  13. trav87

    USA: If you missed the change from Daylight to to Standard Time

    Checked the BCM and it shows the proper time, but the IP phones registered there all show +1 hour
  14. trav87

    How to set up Paging overhead?

    We use a Viking DNA-510, connected via an analog extension, with a lullaby recorded on it for when babies are born. It allows prerecorded messages to be played, as well as a live announcements.
  15. trav87

    USA: If you missed the change from Daylight to to Standard Time

    What about changing a BCM50 that is acting as a SRG? Our main PBX and MCR sites all changed, but one site who is connected via a SRG is still showing an hour off.
  16. trav87

    Mini Carrier Remote connection woes

    Turns out we had a defective serial cable out of the packing. Swapped it out with different cable and logged in no problems.
  17. trav87

    Mini Carrier Remote connection woes

    I am trying to log into one of my MCR using the P5 jumper. I need to get in to undo a change made Monday by our vendor that is causing issues. They are unable to get back on site until mid morning tomorrow. I am using Netterm, a straight thru serial cable, 9600 8 none 1, VT100, and have had...

Part and Inventory Search

Back
Top