Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. DeltaDJR

    2400IMX - Can not backup Memory to HDD.

    There is only one CPU in this system, and it is labeled SC32 PT-2200 BOOT SP3351 B 2A It is circa 2000, so it has a floppy disk, not a flash card. What does the CFCS command do? I am not familiar with that one and I don't see it in the command reference manual that I have here. Thanks.
  2. DeltaDJR

    2400IMX - Can not backup Memory to HDD.

    After making some changes to my 2400IMX, I went to backup the changes from the MEM to the HDD. Once I had the appropriate options chosen, I hit start and I got the normal "PBX I/O running" in the window with the time hack. It ran forever and never moved past the "data memory" stage. I watched...
  3. DeltaDJR

    NEC 2400IMX DRU Installation

    I have my problem solved, and thanks to everyone who helped. Here's my mistake. Once I discovered I could not use my last 32-bit slot, I moved to an available 16-bit slot in the upper PIM. When I did that, I made a mistake in the LEN number because I had the module group wrong in my head...
  4. DeltaDJR

    NEC 2400IMX DRU Installation

    I am using a TEC of 3. I've actually used this same configuration before, I am just confused as to why I can not make it work in the slots that the manual says it works in.
  5. DeltaDJR

    NEC 2400IMX DRU Installation

    I tried programming a LEN but the OPE light on the card still does not come on in that slot.
  6. DeltaDJR

    NEC 2400IMX DRU Installation

    After doing a LLEN on the LENs associated with slot 23, I see that there are several routes programmed on various LENs. According to the manual, I can use slots 5,8,16, and 18, but when I put the DLI board in those slots and activate the MB switch the N-OPE LED stays lit and OPE will not go...
  7. DeltaDJR

    NEC 2400IMX DRU Installation

    When using the DLI Card in some of the lower slot numbers (i.e. slots 5 and 7), do I need to make sure the next slot is vacant because this is an E1 card? I was under the impression that when using a 32-bit card in a 16-bit slot, you needed to leave the next slot in the PIM open, and I have no...
  8. DeltaDJR

    NEC 2400IMX DRU Installation

    I just purchased a SP-DAIA DLI Card and a DRU-30A-B for use with my 2400IMX. I've installed the DLI Card in the last available 32 bit slot in the stack PIM0 SLot 23. The LEDs indicate a good link, and I have run the loopback tests to verify a good connection, but when I try to activate a...

Part and Inventory Search

Back
Top