Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Exchange 2000 --> 2007 Across 2 Different Forests...
Here's the scenario... I have a Windows 2003 forest "old.com" running Exchange 2000. We as an IT Department decided to build from scratch a new domain called "new.com" and run Exchange 2007. I do not want to migrate our entire company in one night or weekend, and therefore need both...- Dektaki
- Thread
- Replies: 0
- Forum: Microsoft: Exchange
-
Channel-Group Configuration Needed
Switch 1: Show Run: BOI-2960G-1#sho run Building configuration... Current configuration : 4017 bytes ! version 12.2 no service pad service timestamps debug uptime service timestamps log uptime service password-encryption ! hostname BOI-2960G-1 ! enable password 7 100F081001123F121926 ! no aaa... -
Channel-Group Configuration Needed
Here's Switch 1's "show etherchannel detail" BOI-2960G-1#sho etherchannel detail Channel-group listing: ---------------------- Group: 1 ---------- Group state = L2 Ports: 2 Maxports = 8 Port-channels: 1 Max Port-channels = 1 Protocol: PAgP... -
Channel-Group Configuration Needed
I have 2 Cisco 2960's . I use Ports 45 - 48 in a Trunk mode and have created EtherChannels to attempt to double my link speed between the switches. When I do a "sho etherchannel detail, I show that on Switch 1 port 47 is "Down not in bundle" and on Switch 2 "Down not in bundle". However the... -
EtherChannel Configuration
Well, my implementation went well. I ended up ultimately as my original thread stated going with "channel-group # mode desirable non-silent" on all 4 of my 2960's, and everything is working great. I ended up ditching that HP gig switch because I didn't want to deal with mixing equipment in our... -
EtherChannel Configuration
I didn't setup the switches in a full mesh as I didn't want to tie up the other ports to do so. So really it's just: Switch 1 --> Switch 2 --> Switch 3 I had counted on STP stopping the secondary links in the event that the etherchannel was not setup properly. And in fact, that's exactly what... -
EtherChannel Configuration
Viper, It was in fact exactly as you stated in your first response to me. I now do the "show int etherchannel" command and both ports come up as "UP Mstr In-Bndl" now! So let me throw in a monkey wrench into the equation. Since PAgP is Cisco proprietary, what will the outcome of me... -
EtherChannel Configuration
The ehterchannels go from switch to switch. My hope was to bond two Gig interfaces to make for a higher uplink between all 3 switches. -
EtherChannel Configuration
I have 3 Cisco 2960's all 10/100/1000. I use Ports 45 - 48 in a Trunk mode and have created EtherChannels to attempt to double my link speed between the switches. I'm not sure that I'm getting that at this point because when I use the "sho int etherchannel" command it shows the secondary port...
