Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
EWAN QOS at the aggregation point
What hardware is anyone using for EWAN aggregation (MPLS Ethernet Handoff) that supports QOS for the individual subinterfaces at the aggregation point? -
QOS on EWAN aggregation point
Hello, I am trying to setup MQC QOS for an EWAN solution utilized by our sister company and have just discovered that I cannot apply service-policy to an ethernet subinterface on the 3725 that was provided to aggregate the vlans on the provider handoff. What are you all using for QOS on EWAN... -
2950 switch, enable VLAN interface and others shutdown
OK, I reread my doco and there can only be one management VLAN. I guess that makes sense. VLANS all seem to be working otherwise and getting routes from the core switch so I guess that means my trunking is OK too. I hate when I feel dumber than I actually am. :) -
2950 switch, enable VLAN interface and others shutdown
I am more of a router guy, but I am having a 2950 issue, need to enable additional routed VLANS on my 2950. Every time I create a new VLAN it is shutdown in the startup config. If I enable it, it shuts down the previously enabled VLAN. I know I must just be missing something simple but can't... -
How to find IP?
Rokit, This is a cisco swithing forum, but I'll take a try at helping. SInce you bought it secondhand and don't need the configuration that is on there, I would reset the switch to factory default, then reconfigure the IP Address. Follow this link to the factory default reset instructions... -
Extending QOS over ATM network
Hello All, I posted this under the ATM forum, but since it doesn't get much action, I thought I might post it here too. As a newly hired engineer I have been tasked with extending our QOS across our private ATM network comprised of Cisco 8510 MSR with Cat6500s at the edge. I am having... -
Extending IP QOS to ATM network
Hello All, As a newly hired engineer I have been tasked with extending our QOS across our private ATM network comprised of Cisco 8510 MSR. I am having trouble finding any info on QOS over the ATM network. Lots of generic documents say it is coming, or is now available but very limited...- gnasses
- Thread
- Replies: 0
- Forum: Data Transmission general discussion
-
Quad T-1 per-packet sharing on 2620XM
yes, all T-1 lines go to the same place. What is the difference between Bonding into multilink interface and per-packet load sharing, both concenptually and ios command line? As far as I know CPU usage has been low for them, but we don't monitor or log it realtime. -
Quad T-1 per-packet sharing on 2620XM
Yes, I am aware that they will need to upgrade for any additional services or demands, and we have made the customer aware of this. Eventually, they will be on a 2812 with DS3 over ATM, but this is probably 270-360 days out. DS3 + router cost would be a significant expense for them right now... -
Quad T-1 per-packet sharing on 2620XM
Hello, Have a customer running 2 t-1 link on a 2620XM with per-packet load sharing and fair-queue, everything runs great. Customer wants to upgrade to quad (4) T-1 and they have 2 available WIC slots to add cards to. An engineer from the LEC says that they will not get good performance from...
