Search results for query: *

How can I get sendmail to use a specific address as the *source* IP when sending outgoing mail? I am trying to get my reverse lookup right to get rid of "may be forged" messages in the header of outgoing mail. one IP address on the computer where sendmail is running is set up correctly to...

I have enabled trap logging on a Cisco 2801 router (OS 12.3(8)T6) to a linux syslogd. I have done the same recently with a PIX515. The problem is that I am not getting any informational (6) level msgs even though "logging trap informational" is set. I do get the lower level msgs in the syslog...

We have a PIX 515e running OS 7 a the hub. A Cisco 2801 on one spoke that's been working reliably. I just added two SOHO spokes -- one with a Netgear FVX538 VPN router and one with a generic Linux box running CentOS4 using IPSEC Tools (setkey and racoon) to configure the kernel IPSEC support...

We have a PIX 515e (OS6.3) with outside,dmz and inside interfaces. Public IPs are static NAT'd to private adrresses in the dmz. From inside our network we have to use the private IPs of the DMZ computers, instead of the public IPs that the rest of the world sees. I understand that this is a...

We have a PIX 515, with 3 interfaces -- outside, inside, and dmz. The 515 inside interface connects only to a 2600 router. the router has two other subnets (one a local switch and the other a private T1 to another location. I want to be able to VPN into the LAN and be able to work as if I was...

We have a new PIX 515 setup with three interfaces, outside, inside and DMZ. Problem: When I VPN into the inside interface (Cisco client 4.05), I cannot access machines in the DMZ. An old post on this forum suggests that the PIX can't do this yet but when the 7.x software comes out, it will...