Search results for query: *

New to Windows 7 and have not been able to access network resources when connected with Cisco VPN client 5.0.6. Everything installed fine and connects OK but will not comminucate with any resources. This same setup works perfectly on a XP Pro laptop. Both units run Symantec Endpoint...

The link below is to a Cisco WAN configuration guide. It is very useful and has tons of info in it. http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_book09186a0080080f69.html

...... .:||||||||:. /////// <----------/ _ _ \------------- ( o o ) \\\\\\\ -----:----------@@@@-------: :-------@@@@----------:------ `--' Private Network Access Restricted To...

When I try enabling dot1q on a 2611 it will not communicate with the switch and/or anythig. Below is config. Used identical setup on 1841 and works great. Is there something special on a 2611 that needs to be anabled for this to work? Switch interface FastEthernet0/7 switchport mode trunk...

I was wondering if anyone has tried usning a NM-1E or NM-1FE in the module slot of a 2800 series router. Those are not listed but there must be a way to add an additional ethernet interface to these routers.

Hello.... I have copied a new IOS into the flash of my 2811 router. At this point would I just delete the old file and reload? Why is the old file called "falsh"? It was this way from the factory. router_2811#sh flash -#- --length-- -----date/time------ path 1 17239596 Feb 21 2005...

Hello.... Have a Cisco 2950 switch with the following configuration lines: monitor session 1 source interface Fa0/1 monitor session 1 destination interface Fa0/7 ingress vlan 1 Fa0/1 is ethernet on router Fa0/7 is 2003 Server with Web filter This was setup to allow the server to filter and...

Something interesting..... Have a 2600 series router with 64/16 max memory and just tried to load the latest 12.3 image for it. Said it requires 64/16 memory so should be no problem. Erased flash and proceeded to load and received an error stating that I did not have enough memory. Figured...

Hello.... Have wierd problem. Have a Cisco 2811 router with two wic-1dsu-t1-v2 cards. Two t1 point to point lines to building 1/2 mile away. Both t1 lines bonded together on a multilink interface which connect to a Cisco 2611 router with two wic-1dsu-t1 cards configured in the exact same...