Search results for query: *

What's the right way to reset a port that hit cp-limit? I had accidentally setup a network loop, but have since corrected the problem. The only issue is that the ports that were downed due to cp-limit won't come back up again. As such, I have moved the GBICs to new ports and it's working again...

I'm missing a lot of addresses in the SNMP dot1dTpFdbPort table on my 5510. It's running 4.1.0.5 software. Basically, I can see the address when I run from the switch: "show mac-address-table vid 123" but when I run from a host: "snmpwalk switchname dot1dTpFdbPort" I'm missing many MANY...

I have two baystack 5510s (v4.1.0.05) each with an MLT connected to two passport 8600s (3.7.4.0) configured for SMLT. I have runs some tests using netperf from six Sun V210s (with 4 interfaces each) and I can't seem to get the traffic to loadbalance between the two links. I'm monitoring the...

I have started this thread over in the Nortel forum (http://www.tek-tips.com/viewthread.cfm?qid=1015965&page=1) but I figured I would ask here as well, since it involves both platforms. There are more details (switch configs) in the Nortel thread. Thanks! Tony --- question below --- I have a...

I have a 8616GTE in my Passport 8600 and I'm trying to trunk it to a WS-X5234 in my Catalyst 5500 (link the new Nortel network to the old Cisco gear for testing). I've got a sigle port connected with a single crossover cable, but I'm not getting any link. I know the port is good and the cable is...