Search results for query: *

I have a Definity G3V9SI. I have an ISDN trunk group Between It and a Cissco Call manager. I have a direct inward number directed to the Cissco from the Definity. The Inbound caller ID number displays of the caller but the name passed to the Cisco Call manager is the Name of the definity...

We have a G3-V9 release. We have 2 ISDN-PRI Trunk Groups. We are getting the in-bound number but no Name. The service provider says they are sending the name as part of the facility message. The PRIs are out of a Lucent 5ESS. Is there some where I am missing a translation to enable this?

I need to connect two G-3 switchs together. The purpose is to allow Switch B to access the Long distance T-1 Pris in Switch A. I need to Send The Station Caller ID From switch B to Switch A. I have a seprate trunk group in botn the A & B switches. They are connected together by a T-1. I...

I am in the process of moving a g3v6si into a building that has another g3v6si. I would like to have the moved switch to trunk through the existing switch which as adequate ISDN-PRI Trunking. The moved switch will not have any incomming trunking. It is basically a outbound customer service...

When I implement call forwarding on a single line port forwarding to another station it works fine. If an outside caller calls into the did number of that station...the call forwards ok however if that call is still in progress and a second call comes in on the DID# the call rings at the...

I have a problem with a checksum error/RAM on a cold start. I was sent a new TN790 but it has the wrong version firmware. I have G3V6I.03.2.239.5 . The card they sent has G3V6I.03.2.239.7 . Is there a way to copy my firmware to the newer software card. If I try and boot with my Flash card...

I am connecting two g3V6si systems together. I am using ISDN tie trunk/Tandem configuration. when Switch A accesses the outbound ISDN trunks of Switch B to dial out.. through ars... Will Switch A's isdn public/unknown format numbering information be transfered to switch B and be sent outbound...

Is there any terminal emulation programs or hyper terminal set up that will allow a laptop or standard computer dial up to a definity switch? I can connect but cannot do page up/ down commands or enter commands. If I connect an avaya terminal to a modem and connect to the switch...it works...