Search results for query: *

thread798-1498634 Does anyone know of a tool or a plan for Avaya to make a tool for this data base conversion? To me it is ridiculous there is not one. This is what everybody is doing now.

I have been upgrading some pbx's to 5.5 and noticed I was getting some messages about ssh so I figured I would give it a shot. So I fired up putty and logged right into one of them with no issue using admin1 and admin2. Then I tried the other one and it keeps saying access denied. They are both...

Anyone have any good advice for someone getting ready for the ccie voice lab? If so sent it to me. Also send me any advice on bootcamps. Thanks in advance for any help.

Well I have spent the past few weeks with the viens on my forehead poking out. We were installing a CS1000E. I hope to never do that again. The fact that there are no trunks except copper in the E brought many issues to light I had never thought of. All digital trunks must come through the...

On a call pilot is there a way to send message notification to a email address. I want a way to get a email to my blackberry when someone leaves me a message. I have desktop messageing so I can see the messages in my outlook but I aslo want them to go to my blackberry email if possible

I am trying to implement a Nortel VOIP solution over a Cisco data network. We are having excessive jitter and latency issues. All the voice is staying on a layer 2 network. We have 3550 at the access layer, 4006 at the distrubtion layer and 6500 at the core. The 4006 and the 6500 are running...

I have a signaling server set up set up with h323 peer gateways. All calls go to an 81c succession 3.0. When I call an internal extension from the gateway everything is fine the the set shows the internal 4 digit number of the h323 peer but when the call goes to pstn we still only send the 4...

when processors are switched the connection to the media card is momentarly lost. I have a theory this is an arp table issue in the data switch. I have seen it on cisco and nortel data switches but never had an issue with the old hubs we used to use. Now nortel no longer supports hubs. Has any...

Has anyone had any luck using the new set based dch monitoring tool in 3.0. I have been tring to get it to work with no luck. I define my tn's in ld 15 in the mon secetion but when I issue the command "enl msgi x debg set" i get dch009.

Has anyone had any issues with external calles forwarding to menus? After upgrading to 3.0 any external calls that were forwarding to MM menus now say "the subscriber "forwarding number" does not subscribe to this service". Like it was an internally forwarded call. I have found a work around by...