Search results for query: *

I have a number that I would like to be able to manually forward to one of three different menus depending on the status of a system. The main DN is 2222 I have built the 3 menus and 3 phantom (3331, 3332, 3333) with DCFW to the message center DN and they work if I call directly. However, If...

I have MCR on 5 sets in addition to two primary SCR on each set. Calls to MCR go to VM if no answer. Can I change so that MCR rings forever? I thought I did this before with secondary forwarding or maybe im crazy.

Using Meridian Mail on Opt 11C I have setup a TOD menu. business hours it points to a voice menu. (This works fine) Non-business and holidays I need it to transfer to extension. How do i do this?

Is there any advantage to distributing heavy users over different modules? I have 4506 with 4 X WS4548 Right now all heavy users (servers) are on one particular module. Throughput is not that great. Wondering if spreading them out between the other modules would help.

I was trying to change the phone so that when I was on key 0 and got an incoming call it would ring up to key 01. That doesn't work and now I have no VM. Can someone point me in the right direction. Has it got to do with MARP? TN 7 6 DATE PAGE DES DES SWITCH TN 007 0 00 06 TYPE...

I used IDC for DID translation. How do I remove an IDC entry? I can add then but cannot figure out how to remove an entry from the table. I have just been leaving them and re-assigning them when i need it.

I have been looking to go from a 3x8 DR1 to Dr5 or DR5.1 to gain caller ID and Class MWI. Looking on Ebay I see DR5 and 5.1 What is the difference between the 2? Anything worth worrying about?

I have a 3x8 that was in use for a while then moth balled for about a year. Now that it is back in service I can not get in to some of the config areas. I was trying to do a factory reset in hopes that would clear up the problem. After searching for some information, the only thing i came...