Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: panhead13
  • Content: Threads
  • Order by date
  1. panhead13

    6.1 upgrade 7.0

    quick question. MICS 6.1XC NAM 4.1 upgrading to 7.0XC should i leave the Nam powered down until the Mics is completed with the upgrade or power them up at the same time
  2. panhead13

    Outbound transfer and off-premise notification

    system: 4.1 mics voivemail: 4.0.04c outbound transfer and off-premise notification was working just fine. customer had a different vendor to upgrade the software to XC. Did not receive any reports of a problem with the transfer/notification until last week. built new mailboxes and they will not...
  3. panhead13

    Voicemail messaging to POP3 email accounts

    i know both the NAM nd call pilot support desktop messaging. the question i have is, will both support sending the voice messages to a POP3 email account?
  4. panhead13

    Nam Voice mail desk top messaging

    1. can a NAM voicemail with desktop messaging have their voice messages sent to an email server POP3 software? 2. will the above work with the the call pilot 150 with unified messaging?
  5. panhead13

    Event messages

    I have a NAM running fax messaging software and desk top messaging. I receive continuiosly EVT 609 and EVT 995 in my telephone system log. 1. what are the evt messages 2. How do i correct
  6. panhead13

    OUTBOUND TRANSFER FROM CCR TREE/MAILBOXES

    I have a NAM's Voicemail 4.0.04C with 14 channels. Four are available for outdial. The first outbound transfer will go thur. The second and third outbound transfers get a "party not available or busy signal", and the process begins again, 1 out next two no go's, 1 out next two no go's etc. I do...
  7. panhead13

    ACS Partner point to point T-1/DID mapping

    I have a ACS r6.04. The upgrade T-1 problem patch has been installed. System has been programmed with the channels programmed as DID. The DID mapping table has been programmed. We can access the point to point T-1 and call into the NEC system in Michigan. The problem I have is when the NEC...

Part and Inventory Search

Back
Top