Search results for query: *

Hi everyone, Can someone tell me what the following error means: 1799232mS PRN: +++ START OF ALARM LOG DUMP +++ 1799232mS PRN: ALARM: 08/03/2007 13:05:42 IP 412 3.2(54) <TLB Data Load Error> CRIT RAISED addr=46414449 d=12 pc=009aa5dc 01cdbf1c 009b371c 00abb814 00abbb78 00ab3714...

Hi, I am looking into a fax solution for our IP Office 412 (with T1 and PRI). We've looked at several products, including MultiTech's FaxFinder and GFI Faxmaker. I was wondering if anyone has had experience with either and if one is better than the other as far as integration with the IP...

I’ve been noticing in our SCN (running over a VPN) that the user directory information doesn’t sync across sites anymore. This information used to sync on an older release and over the same VPN. You can place calls back and forth with no problem. The main site is an IPO 412 3.1(56) and the...

Can someone steer me in the right direction with LCR? I have a PRI and a T1 hooked up to an IPO 412. We’re having higher than normal traffic inbound on the T1, so when someone goes to dial long distance (goes over the T1) the call does not go through. What I’m trying to accomplish is setting...

Has anyone experienced trouble with hunt groups producing busy tones when no users are available? I have a linear hunt group set up with 10 users and when all lines are taken additional calls are dropped and no busy tones are produced. No voicemail is set up for this group. This is coming...

I’m having problems with inbound calls disconnecting after a minute of ringing. The system is an IPO 412 ver. 3.0(44) and is hooked up to a PRI and a T1. I’m having the issue on inbound calls off of our 800 number which rides the T1. I’ve tried the same scenario off of a DID number on the PRI...

I’m having a problem with conference calls on our IP Office. Once a third person is added to a conference through a telephone on the system, the line ends up getting heavy distortion on it. The distortion is to the point where you can’t hear any of the other people in the conference. Our...

I’m having a constant problem with people leaving their phones off the hook. We have an IPO 412 Rel 3.0 with 4412 phones. What happens is that the phone is off the cradle a little bit and the phone keeps the line active (Dial is displayed on the phone). In call status I can tell that this is...

Does anyone know if inbound caller ID (sent as * ANI * DNIS *) on a T1 is supported by IP Office? We have an IPO 412 (2.1.27) with a Qwest T1. We have three 800 numbers pointed to the T1 and Qwest was sending * ANI * DNIS *. I couldn’t get the 800 numbers to route correctly, so I had Qwest...