Search results for query: *

I have a 6509. In it are some 6148 line cards and some 6348 line cards. Most devices I connect to those cards that are more than 160' away will not establish a link at 100/Full. 10Full or Half or 100/Half works fine. Now, I plugged an old 6248 in there and it handled all 4 permutations well into...

Has anyone tried moving a 40+ MB file from the flash of a 6500 catalyst running a sup720? I am having FT completion problems. Does anyone know of any inherent FT problems when transferring large files from this Sup's flash card? I'm pretty sure its not the network in general. Its pretty clean...

In show version, there is the following field that describes installed memory: cisco 2610 (MPC860) processor (revision 0x202) with 53248K/12288K bytes of memory. What are the "numerator" and "denominator" values listed? In this case they add up to 64MB, which is what is installed. But why the...

I currently have: ROM: System Bootstrap, Version 11.1(19)AA, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1) Is the ROM socketed? If so, could I buy a newer ROM? If the ROM is upgraded are there any gotchas? From what I can tell I can't update it with the same mechanisms I use to update IOS versions...

Inside of my inst_arn.bat file I see: :IP_CONFIG: echo "" # Load IP + ARP Protocols. set_protocol wfARPLoad set_protocol wfIPROTOLoad set_protocol wfSNMPLoad set_protocol wfTFTPLoad I can't perform this outside of the batch file. Is this loading some module from the arn.exe? Andy Ford Austin

I NetBooted an ARN running 14.20r5 for both its image and config. The Netboot went ok and I logged in to the TI. A dir showed nothing on Flash, so I attempted a tftp get and was told the TFTP service was not active. I issued a set wfTftp.1.0 1 and I was still told TFTP service is not active...

I am trying to set up some corporate guidelines around this. at present, I think there are three ways I could rollback a configuration to an earlier version Have an earlier version offline that I send to the router's flash and then reboot Could simply do a copy start runn if the running config...

Two MIB questions: 1. What obj.attr pair do I need to find the IP address entries for my various interfaces. I have perused wfCSMACD, wfIf, wfIP, wfCct, etc. 2. I know it is encrypted, but in what obj.attr location does the Manager password live. Thanks, Andy. Andy Ford Uplogix, Inc. Austin

Hello again, does anyone know what BayRS's default timeout is once a TFTP transfer has begun? Ie, how long between packets before the router gives up and aborts the transfer. thanks, andy Andy Ford Uplogix, Inc. Austin

Ok, I have a BPS2000 running BOSS 3.0.0.54. In CLI, there is a "config network" command that the docs say will load an ASCII config, via TFTP, into the switch. Where does this config come from? I can't find a command to SAVE a text config, only READ a text config. Is there a known format for...

Is there anything in the BayRS world similar to Cisco's ROMmon mode? For example, if I had an ARN that had a couple of corrupt OS files and wouldn't boot, is there a boot helper cli that would either allow xmodem file transfers or tftp boot setup? What diagnostic/recovery options do I have via...

Doing it in BCC is simple. However, I need to do it in TI. I haven't found the wfxxxxx obj.attr to set. According to MIBdepot, wfIfEntry.7 (Admin Status) is read-only. When I disable via BCC, that attribute changes from up to down. Is there a way to set it via TI or is there some other wfxxx...