Search results for query: *

I have purchased KA-281 software to keep a "backup" of program parameters of two separate TD-816 installations. Wanted to work "offline" to print out custom overlays but found that software version will not allow to work non connected to system. This is registered version with dealer access...

Configuration is 4 CO & 5 stations. I wish to use a fax at a jack but maintain CO line for rest of system. Previous maintenance on system in other building was Panasonic Eas-Phone that required me to use Viking fax/voice switch in series on incoming CO , then to system CO port. Would the same be...

Does this older analog system support capability to assign a different ring tone for a new incoming CO line that will ring on assigned stations only? Ideally, this line would not be in normal hunt group? Know Avaya products..this system is significantly older, obviously do not have ref manual yet.

Just installed R6.0 ACS to replace a older Partner 3.1 processor. Need assistance to have Station 10 and 11 answer the six incoming lines. Currently all stations are ringing incoming lines. What program setting to have station 10 & 11 (Operators) to handle incoming lines first, then if not...

The existing configuration: SLOT1 (206 E R3.0), SLOT2 (206 R3.1), SLOT3 (Processor 3.1), SLOT4 (206 R2.0), SLOT5 (206E R4.1) Would I be able to upgrade seemlessly to ACS? What's the current release? If the existing Partner 3.1 has 7 of the 8 available line inputs used (I have four 206 's)...

What's symptom of possible bad battery backup? Current Processor (3.1) has had history of power outages, but system usually comes back up all ok. It's now reported that Feature *71 doesn't work as well as individual pages to assigned stations. Am I missing something else? Is there an upgraded...

Have I missed something? Current configuration: 206E R3.0 (Slot1), 206 R3.1 (Slot2), Processor Module 3.1 (Slot P), 206 R2.0 (Slot 3). Powered down rack, added 206E R4.1 into slot 4, installed tested line into top jack(Line 7?). Powered up rack, all green indications across 5 modules...

Have a 5-bay configuration (206 R2.0) (206 R3.0) (Processor) (206 R 3.0) (Empty) with all incoming lines used. Bought a new (206E R4.1) to be used in empty slot to allow another line to be installed. Want to be able to use this line exclusively for 5 different stations,along with existing lines...

Have a 5-bay configuration (206 R2.0) (206 R3.0) (Processor) (206 R 3.0) (Empty) with all incoming lines used. Bought a new (206E R4.1) to be used in empty slot to allow another line to be installed. Want to be able to use this line exclusively for 5 different stations and not part of other...