Search results for query: *

Hi, I have an existing site2site connection. How do I limit access from the remote net to certain hosts on the inside network. I tried with a deny in the cryptomap acl but it does not seen to work. As a test I tried to deny access to 10.10.20.50: access-list outside_cryptomap_4 extended deny...

Hi, I have a site-to-site vpn connection. It works fine from vlan 1 both ways. I have a sub interface with a vlan. From this vlan it works to and from my inside network. I can connect/ping from the remote site-to-site vpn but not the other way. Anyone here that can point me to the right...

Can't find trunk encapsulation option on my new 2960G (12.2) when configuring port-channel? Did cisco remove this option? Is dot1q now default trunk encapsulation? Thank you, Morten

My vendor says that i'm wrong when I think that I used to get X records in my CDR. Now I only get N, S, E records. My vendor claims that an X record does not exsist. Can anybody please verify if I am wrong or right? If I'm right to where should I point him? Would CDRX set to yes (LD 16) give...

Hi All I have a problem. I have a MCR on several 2000's. I want this MCR (Emergency no.) to be transfered when unanswered. Is this possible? Can I put the MCR on Key 0 on one set then make it MARP and control it in that way? Thanks, Morten

Can anyone help me with a copy of a manual for Q-Watch from Telecorp? Thanks in advance.

Hi When I LOGO on our option 61c I get TTY #02 LOGGED OUT 23:07 27/2/2004 SESSION DURATION: 00:00 On our option 11c I only get the > prompt. Can I configure the option 11c to give me "TTY #xx LOGGED OUT....." as response to the LOGO? Thanks

Hi When I connect to a service TTY on my option 11c I get the check in, check out messages from the PMS TTY. Can I stop the debugging/messages on my service TTY? Is it possible to turn off all debugging (BUG/DCH/TFS etc.) on one TTY? Thanks

Hi I have a problem with some ACD phones (2008). When they hang up the "Not Ready" is activated and the phones are "Logged Out". How can I prevent automatic log out on hang up?

Hi I want to make a hunt group and made the following: >ld 20 REQ: prt TYPE: ght LSNO 6 SIZE 6 RNGE GHLN 0006 GHT PLDN DNSZ 8 STOR 0 3004 STOR 1 3000 STOR 2 3001 STOR 3 3007 STOR 4 3019 STOR 5 50 How can I define that when users dial...

Hello, Can anyone help a newbie? I (think I) know that the following FCR is used for a route on our option 61C where we can forward to extenal numbers allowed by this FCR (what does FCR mean?). How do I add and delete numbers in this FCR? LD 49 REQ prt TYPE FCR CUST 0 CRNO 9 CRNO 9 INIT...