Search results for query: *

Pls can you let me know how to configure E&M Tie trunk using Definity G3Si and CISCO router 3660. I have checked one document from net and tried with the wiring and programmign etc. Can anyone share the setting with me

I have tried intsalling the Avaya Message Manager and it is done perfectly. However whenever i try to log into the system by putting the Audix Server ID, Extension, Audio and PAssword,, it gives an error saying :INVALID ARGUMENT: As per manual it says network communcation problem. Can you let...

Hi I tried connecting the 715 Terminal to the EPN, but the terminal only powers up , The login scren does not appear..What cud be the problem

I cannot do a "reset pnc interchange " since it gives me the error " must release all port netwrok connectvity" The standby PNC is busied out . I cannt release it since it says to relase standby pnc components. How do i release such standby pnc components

I have a CLAN board configured in one VLAN. Now when i use the ASA software for administration it connects on the VLAN wher the CLASN board is installed. But it does not conenct if we use the ASA from any iother Vlan. Can u tell me whether there is any settings to do or configuration for the CLAN ?

can u tell me in Definity Long Range Trasceiver what kind of Fibre connector is used ? SC or ST type

Hello I have a third party IP Phone from Innomedia. So far i am able to make calls to this phone but i cannot 1. originate cals from the IP Video Phone of Innomedia 2. The calls made to the IP Phone get disconnected after few seconds Thanks

Hi I was doing some changes in dial plan. In doing so i cha ges the setting for string=0 from attd to ext. I am trying to get it back to att however it gives the error saying "0" in use. so i tried to remove the att consoles when in idle mode however i get the reply as "error...