Search results for query: *

Hi, i have 3825-Cisco router connected to a layer 2 link going to a remote site and cisco-4503 core switch as my distribution switch. my question how would i enable/configure the auto-qos in my cisco router and core switch for my avaya system. i have two Voip traffic in my network the IP...

Hi Guys, i have activated my dcs feature in my IP trunk on a S8710 server with CM3.0 same with the other server. on calls i have problem.. it will display the name but the extension it will display only the first 5 digit not all the seven digits e.g. 48100 supposed to be 4810000. do miss...

Hi Everyone, how do i able to check if EMMC server properly started it's internal application process after a longer power down, what linux command do usually issued to EMMC server if needs a start up. i've tried the reset button but no luck. we are using S8500B CM3.0 with EMMC ver 1.0.17 "We...

Hi Everyone, we had a Avaya S8500B EMMC server connected to a clan this was working last week, when i made a testcall it give me a busy tone but the signaling and SIP trunk are in service. for the trace i see 1191 error it said network failure. any ideas y this happening? thanks n advance,

Hi All, i have 5 analog and digital phones under cor 20 with Outgoing Trunk Disconnect Timer (minutes):2 activated but the timer will not cut if these telephones tried to call outside. my trunk is ISDN 30 channel thanks

Hi does anyone have an idea if i could back-up witness by monthly basis? Thanks

Hi All, does anyone here having this issue. I'm having problem with my Avaya IA770 INTUITY AUDIX. we cannot leave message to a station it will always say NO NAME RECORDED after pressing # sign!, when i checked the greeting recording it will say NOTHING TO APPROVED!. this was working before, i...

Hi Everyone, does anyone have this patch for CM 5.0 00.0.825.4-15759 (SP3). i'm in need this patch for my S8300 server. Thanks in advance, Kabudoy

Hi All, may incoming call suddenly crash out when i list trace it it shows - denial event 1641: Permanent seizure D1=0x830001 D2=0x80 - when to dialed from my celphone it gives me two rings then a long tone, my outgoing is working fine. my trunk is a co type loop-start it working for the two...

Hi All, Need Help. I have a problem with the our cisco created vlan connecting avaya one-x ip phone. this issue is with implementing VLan 1 for avaya one-x and VLan 6 for the PC connected at the back of avaya one-x switch port. the cisco Core Switch is 4507R this is were our medpro and clan...

Hi All, Need Help. I have a problem with the our cisco vendor doing the vlan he insist that our avaya one-x phone had a problem or missed configuration. this issue is with implementing VLan 1 for avaya one-x and VLan 6 for the PC connected at the back of avaya one-x switch port. the cisco...

Hi All, i have problem on my IP phone's having intermittent one way audio in site B s8300 LSP G350 gateway with 8 analog trunks for incoming my main server are site A (s8300 G700). we have a router and switch shared with data network. VLan is not activated for voice and data. kindly see trace...

Hi All, i have replace an old attendant unit 302B+ with 302D+ but i heard a static sound on the handset, when connect back the old one it works fine. any idea would much appreciated. i have definity prologix release 6 with TN2214 digital card. Buds

Hi All, i have a problem with my phone user with flash button so if i could remove tha flash button it resolved the issue i'm s8300 g700. many thanks. Budoy

Hi All, am planning to take an exam towards ACA(Avaya). CompTIA Convergence+ exam is one of the required components. Any inputs on this is much appreciated for my preparation. Regards, Jaman

hey guys want know if am going to administer IPSI card using sat or hyper term where do i connect? does the IPSI adater ring a bell here... just for clarification. tnx,

does anyone know what command on ASA to perform for connecting S8700 and G650? we are planning to migrate to this two system am being assign on presenting this to our IT manager.. any help will do

I've been reading lately about S8700 on a website for a reference coz our company is planning to buy. i see two different model of media server S8710 AND S8720! just want to know where they differ? thanks,

does anyone know about flexicom 200 pabx?

is it possible to assign a VDN number to a trunk group incoming instead of local or Attd? any help would be appreciated am using s8300/g700