Search results for query: *

hi all after upgrade forwarding froam A to B are showing acod and mebmer of route and not a-number calling from outside. anyone know what to do so display shows number Again?

hi all i have a problem in italy some calls comes in ok, but some calls are missing the 2 last digits from some provider anyone have the setup for italy on isdn 30?

hi i have follow the ntp's but i can't get working. anyone have a step by step they know works?

hi all anyone know what the provider comes with in china and how to set it up in an srg?

hi all i have replaced a failed srg50 with a new one have got the keycode on it but i cant restore the backup from the old one get this message "Failed to extract signature from archive" anyone know what to do?

hi all can't get sfa to work on cfw. a calls b that have cfw activete to c and c have sfa in cls,but call goes back to b's fna and follows that instead of following c's. i have tryed everything. anyone have solution.

hi all can only have 3 in conference,but key saids ao6. anyone knows this problem. rel 5.5 cs1000

hi all anyone knows have to remove conference warning ton on rel 5.5 cs1000?

hi anyone have this on a pdf or hardcopy. i know it is a while ago-:)

hi all i have upgrade from 4.5 to 5.5 and all costumer data is there but my password are gone the only ones that are there are the default ones. anyone know was is wrong?

hi all have a rel 5.0 via ip trunks to nrs to rel 4.0 from rel 4.0 normal pri tie to rel 3.0. ext. on rel 3.0 calls ext. on rel 5.0 name and number is ok, but when ext. on rel 5.0 calls ext. on 3.0 only number?? anyone knows what could be wrong??

hi all have partiel reroutning from provider but it donsent work over mcdn any workaround or dosent work??

hi all i have a site that i just put in a pldn for sclu, but the local ext. cant use it they get reordre tone. the pldn is 550 and scl 455 with size 100 so to call the number on place 03 you have to dial 55003 but they get reordre tone after 550 is dial. i can use it from outside using disa...

hi all i have a opt 11c rel 4.0 with a qsig to callmanger rel 4.13,after callmanger have been upgrade to rel 4.13 from rel 4.02. i get cause98 on d-canal from callmanger when an phone on callmanger is call forwarded to another callmanger phone. i mean that last time the callmanger was upgraded...

hi all the promblem is that the co on a local call inside the same city are sending the digits to slow, or one digit later than the others. because from other place it works fine. so if anyone have how to do in germany, i would be grateful.

hi all anyone have the configuration on that specifict in Germany. how the route is make d-canal and so on for both cases?

hi all anyone have that

hi all have a tie on qsig with isgf, problem is when 2 cisco ip sets have call forward to each other: ext 9115 to ext 9100. i get disconnect with cause 98. anyone know of a patch or anyting else i can do?

hi all anyone have a patch for this,old release :-)

22 Jun 05 5:05 hi all anyone have an solution on this setup,have tryed solution seach on nortel and the solution is not working. Inappropriate post? If so, Red Flag it! Check out the FAQ area for this forum! Find A Job or Post a Job Opening Click Here. I2007 (Programmer) 23 Jun...