Search results for query: *

Trying to recycle an old server and need to change the boot order to boot from CD. How do you do this, all it wants to do is boot from SCSI or Floppy? Any help and links to any required drivers etc would be appreciated.

I'm trying to configure VLANS on a 2610 with no avail. What O/S version and how much memory should I have to support this?

After spending far too long looking through Cisco's web site and getting nowhere, I thought I'd ask the question here. Is it possible to install an ADSL card in a 2611 (not XM)and if so what are the IOS and hardware requirements? Bob

Can an 803 be configured to act as a time server for its local network and if so how? Router is running 12.7 IP Plus software

I'm trying to configure one of the routers on our network to sync its clock with a public NTP source. I was told that "ALL" I had to do was to add: ntp peer a.a.a.a to the config and it would work..... HA! I've tried several NTP servers from the lists at http://www.ntp.org and...

A quick question, whats the difference between an "NTP peer" and an "NTP server" when configuring a router?

We have a "managed" network, to which we have read access. We are having problems with the supplier making changes to the router configs and then saying that they had not changed anything. What I would like to do is set up a scheduled task to get our routers configs automaticaly...

Help please. We have a Cisco 2621 router acting as an interface between a VLAN switch and a firewall. The requirement is that ALL traffic from the devices connected to VLANS on the switch is routed to the firewall. This happens when the router to firewall Fast ethernet port is up (Fas0/0) but...

We have a Perle Gateway RAS server which is dying! Its used for incoming connections which should not be a problem to move over to the 3640 but the Perle also allows users to connect to it and access the modems directly. Can this be done with the 3640 and if so HOW? Bob

We have a Perle Gateway RAS server which is dying! Its used for incoming connections which should not be a problem to move over to the 3640 but the Perle also allows users to connect to it and access the modems directly. Can this be done with the 3640 and if so HOW? Bob

I need to be able to assign Remote users fixed IP addresses when they dial in to a 3640 and are authenticated by Cisco Secure. Cisco Secure looks like it should do this OK but when the user dials in they're not given any address. Cisco Secure site on an NT platform. Any and all help would be...

I need to be able to assign RAS users fixed IP addresses. Cisco Secure looks like it should do this OK but when the user dials in they're not given any address. Hardware is 3640 and cisco secure (on NT platform) Any and all help would be appreciated.

As we need more bandwith between the network and servers, I've been asked if it's possible to have multiple fastethernet ports connected between a 2524 and Compaq servers to increase the available bandwidth and share the load. I'm not sure how to do this from the switch so any help would be...