Search results for query: *

Generic question, Has any heard of a DS1 card stuck in loopback mode when it experiences DTE LOS? I had a asterisk box connected via PRI to an Avaya Definity, It lost d channel for some time and never recovered? ne ideas? thanks /mike

I have a 7912G with red and green light solid and no display. ne1 have any ideas of waz up? thanks

When I reboot the system everything is good. But if I do a service network stop then start I goes to a different gateway. in rc.local I have route add -net 192.168.20.0/24 gw xxx.xxx.xxx.39 Do I make an entry in ifup-route? Thanks in advance.

I have a Cisco 7960 SIP phone Does any one know how to reset NAT address back to UNPROVISIONED? Thx

Where can I find the NAT timeout defaults on firewalls? T2F

Where can I find the NAT timeout defaults on the Cisco firewalls? T2F

Hi, what is the best solution for this. Secratary wants to answer the bosses calls on her phone. It needs to ring at both extensions at the same time and she needs to know its his line not hers. If the call goes unanswered. it goes to bosses vmail. thanks in advance. t2f

I have a Merlin 410 and need to do (2) things. (1) Make some phones ring (2) I have some phones that voice over on intercom and some that ring 1 time and flash on the intercom button. need voice over on intercom all. can ne1 help T2F

Does the elite IPK have 1,000 forced account codes? Thanks T2F

Does the Norstar have forced account codes? I need a system w/ 1,000 forced account codes Thanks, T2F

Does the magix have "forced" accounts? I need a system w/ 1,000 "forced" account codes. NE Ideas? Thanks T2F

Trying to change processors I have a magix 3.0 and its backed up to the PCMCIA card. I am having trouble installing that PCMCIA card and restoring into a refurbished magix R 2.2 processor. When i restore it says File not compatabile needs conversion. any Ideas?

NE1 know the programming to restrict 3 phones from international calls only. thnx in advance t2f

Does ne1 know how to repair the 206 modules w/ static I understand there is a chip to replace thanks

cics 6.0 w/ cid trunk module how do i display caller id name?

I have a CICS R6.0 w/ call pilot 100 2 questions Can ne1 tell me how to get CID name to display first I have Name first programmed under (Term & Sets) (Telco features) Cant pass CID info from AA I have vmail ext numbers programmed for Caller ID yes(Term & Sets) (Telco features)

have a magix r2.5 w/ 016TR module. I cannot make outside calls with any port on 016. calls can be transfered and i can transfer out side dial tone to it. but cannot originate outside dialtone help.

Is their a setting so the phones get caller ID name instead of number? I Cannot spare a button for caller id name.

Is their a global setting so a key system can have privacy on all lines on all phones.

Replaced an 016 TRR card With like module but now i have no icm dialtone or talk battery. Under busy & restore it states mismatched board ne1 have an idea?