Search results for query: *

Is there a international standard for equipment mounting racks ? Which are those and from where I can get them ? I am searching for mechanical dimension details which i need to follow for the equipment which I am developing to meet the standards.

I have a situation where the CAT5e cable length is short and I have no alternative excpet use some splicing system to extend the length. What products I can use to splice CAT5e cables ?

What is the best way to document patching details in a wiring closet ? Is it a normal practice to put number tags to bothe ends of RJ45 CAT5e patch cords when used for patching ? Can any one share templates of good practices in documenting a cable infrastructure

Has any one used Krone LSA-Plus module for data transmission between 2Mbps to 100Mbps ? Is it rated for such application ? Where can I get complete specification of this product ?

One of the cisco documents recommend length of V.35 cable versus transmission speed. This document also refers to a graph published in EIA422 standard which gives further details. Can any one provide this graph ? Also some practical recommendations about this subject is welcome.

Is it a normal practice to label both ends of an RJ45 to RJ45 patch cord ? If yes, what is the method used ?

I have a few questions : I have a router with 2 serial interface and one ethernet port. Both serial ports are connected to different networks. 1. Is it possible to use IP un-number to both serial interface ? 2. The ethernet port has an IP number which i use to un-number s0. I also have an...

I understand that while terminating a CAT5e cable, the cable pair untwist should be kept minimum (typically 13mm). Is there any similar guideline for stripping of outer sheath of the CAT5e cable ? Is that just an industry practice or documented in any standard ?

Has anyone used 3M Volition (earlier called SCQ) toolless jacks for Cat5e and Cat 6 application ? How do they perform ? Please share your experience

Some installers who field connectorise fiber cable use Loctite 324 and 7075 based anaerobic structural adhesive. With this the curing time is very fast and within 30 minutes to 1 hour the adhesive cures ready for polishing. Other installers use different type epoxy which takes almost 18 hours...

I am aware of a manufacturer who has capability to manufacture good quality CAT5e, CAT6 and fiber cables. How to get these products tested for compliance to EIA/TIA standards and UL standards ? Where are these labs located and any contact details available ?

What is the chemical content and fire performance differences between OFNP, OFNR and LSZH cables ? I thought OFNP cable must also be LSZH. I am confused !

Can any one suggest me a good labeling software available freely on internet ? I need this to label my wall plates and jack panels.

I am planning to use VF-45 system to terminate cables in backbone and later in second phase deploy fiber to desk using VF-45. Has any one used this system earlier ? Please give your feedback (good and bad both !!)

1. Is it possible to configure cisco router as BERT ? 2. Is it possible to measure Bit Error Rate of a leased line simultaneously when the link is carrying payload ? 3. From the statistics report from a cisco router is it possible to measure BER ?