Search results for query: *

I somehow screwed up the lines on a couple of my phones and have been unable to reconfigure them. I cannot seem to delete a line. I have also been unable to do a line copy from a good extension to this one to clear up the problem. Is there anyway to reset a phone/extension to default?(blank)...

I am trying to test a mail server by telneting to it's public IP on port 25. Here is the hardware scenario: ISP - Cisco 1721 (config below) Public outside address, public inside address My Cisco PIX 501 (config below) Public outside, Internal address inside, NAT and static route to mail...

I am currently running Exchange 2000, and we have had a second T1 installed. I have configured a second Cisco PIX device NAT'ing to the internal IP of my Exchange server, (has 2 NIC's, 2nd T1 to 2nd internal ip.), and have port 25 open as well. Here's the question, Can I just add the second...

I am running CamCommerce RetailStar 6.41, with 4 retail locations, and am looking for an upgrade. I have had consistent stability issues with the DB, and Cam's support isn't that great. I also have limited info for running Crystal Reports off the database, since the canned report feature is...

We have recently added a second office to our company, and I have set up a frame connection between the two offices. now I need to allow for my home users to access the new subnet via thier PIX 501 vpn connection to a 515e. Main office 10.0.0.x New office 10.0.1.x home user 192.168.2.x The...

I currently have an auto attendant picking up calls and "I'll transfer you to the receptionist" and transfers to ex. 10. How do I turn this off? I just want voicemail to pick up after 4 rings or all busy. Thanks.

I have a user (the CEO of course) who is recieving email addressed to user@web.com, while that is not our domain name, we are user@blah.com. I have checked the headers listed below. It appears that the mail is being relayed, and the servers that are relaying have been listed by some of the Open...

A short while ago, my Exchange server crashed, along with Active Directory. It was the only AD server at the time. i was able to recover the server through the recovery console, and get AD started. My backups contained only Brick level backups (a whole other story involving backup exec issues)...

How can I figure out which service pack is installed for Exchange 2000? I need to configure my backup server (Backup Exec 8.6) with the Exchange System Manager with the same Exchange service pack. I am unsure if service pack 2 or 3 is installed on the Exchange server, and need to install the...

i showed up to the office this morning to find my sole AD/Exchange server bluescreened with a nice shrill alarm going off. After rebooting, i was prompted to run the repair utility to fix the corrupt file. Through the recovery console, i ran a chkdsk (which found errors, I did not use the /f...

I have just recently been given the task of implementing Crystal Reports 9, with no prior experience with it. I have been able to figure out how to connect to my DB, but creating the reports I want is beyond me right now. Can anyone recommend any good classes for getting up to speed. I am in...

I have a PIX 515 with a vpn tunnel to a PIX 501 using isakmp key ******** address 111.111.111.111 netmask 255.255.255.255 no-xauth no-co nfig-mode my question is, can I connect to a second PIX 501 at IP 222.111.111.111? how do I specify the second isakmp key? Thanks

I have recently upgrade my network from NT to 2000, in which I created a new domain, and set up a trust, until all servers were brought over to the new domain when I rebuilt them as W2k servers. When clients log in, in the drop down window for domain, the old domain name is still listed. The...