Search results for query: *

Hi all, Most likely my last post on this forum (*sniff*), and one final request for help if possible..... As the corporate wheel in my company turns ever forward, so too the voice system we used has been superseeded by, ahem, a Cisco VoIP solution...(apologies to those of you offended by the...

Hi everyone, Is there a way to dial in to collect voicemail from an external number on a option 11 24.25, with standard Mermail (not sure of version) ? The DN itself has since been moved over to a different PBX, but there is still some messages on the old mailbox/PBX. What I was hoping was...

Hi, Has anyone had failures where 2616 sets get disabled on NT8DO2GA cards ? We have the situation (shown below) occur once every couple of months - for no apparent reason. The 2616 sets are all plugged in, so they are not disabling as part of the overnight LD60 TN sweep. The only point to...

Hi everyone, I was wondering if anyone has experience in activating MCT on an option 11. Specifically, I would like to be able to extend the MCT functionality to record the *actual voice* when the TRC button is hit, eg: receptionist receives malicious call, hits TRC on attendant console...

Hi, Fairly new to this forum - normally involved in Meridian Telco space but was hoping someone may have run into a similar scenario here. Based in the UK, I would like to terminate an E1/q931 circuit onto a cisco 3640, and use this to route voice calls to and from a PBX. Current set-up: PBX...

Hi, I currently administer two Option 11's, and have had little bother doing whatever tasks I needed. However, from time to time I have a problem with access to certain OVLY's. This I would guess is due to the user access level (or whatever it's referred to in Meridian speak) on my current...

Hi, Using Option 11 24.25 with meridian mail (can't remember the revision off hand) and have been asked if I can copy off some voicemails left on a certain DN for evidence in a disciplinary, but I can't think of any 'easy' way to do it. Is there some kind of serial interface I can use to...

Hi, I'm looking for a better way to manage some 2616 digital sets on our option 11 system. Currently 3 company directors have their direct lines mapped to key 00 as the SCR , and the numbers of the other 2 mapped as key 03 SCN, and key 04 SCN. The problem is, whenever one of them is on the...

Hi all, Scenario: Meridian option 11, 2616 phone has CFW set to main reception attendant console (2250). Call comes in on 2616 number and forwards straight away to reception, operator bounces call back to dialled number as person is at desk, just screening calls thru reception first, line...

Hiya, Does anyone know a way to greatly increase the earpiece volume (like, way above what we're getting by using the 'slider' below the keypad) on an attendant 2250 console ? If you speak to someone they can hear you clear as a bell, but you can hardly hear them. Have tried the obvious: -...

Hiya, I have 2 x 2250's at seperate sites using option 11. One is the 'Main' switchboard number (for our distribution centre), the other is the head office reception (secondary number). The two sites are joined via TIE trunks using a coordinated dialing plan (distant steering code) to route...

Hi, I have a problem with trying to set up phones for the directors of our company. Currently they all share a very large, open office space - and wish to be able to pick up each others calls (before they CFNA to the PA's phone) if they're in the office and the others aren't. They are not happy...

Hiya, I was wondering if anyone had direct connected the 2250 attendant console via serial port to a PC natively ? (ie, without nortel or third party software). I currently have a 2250 that I'd like to test to find out if I can see the raw data thru the serial connection onto my laptop using...

Hiya - Have posted this message with thread 798-644942 ,but thought it may be a more general question for the group.... We have an Option11 trying to connect tie-trunk to cisco 3640 rel 12.2(8)T5 - do we definitely need the VWIC (voice modules) for the cisco to convert the voice signal to...

Hi, I was wondering if anyone had information on interpreting CDR records from a Meridian Option 11 (rel 24.25) Basically, we currently have output spew across the terminal (via tty 2) - which is okay (although a little annoying!). I would prefer to collate this information to a file somewhere...

Hiya, We currently have a workaround whilst waiting to get voicemail configured properly on our Option 11c whereby one analogue DN has a telephone/answering machine (BT Synergy 2150) attached. This is basically the line staff use to call in if they can't make it to work, and leave messages if...

Hiya, I have been asked to set up certain security on our meridian option 11c for international dial and need a little help with getting the SPN mapping to do what I want. Basically - I need to know how I can create lower level internaional dial access whereby certain phones which do not have...

Hi, I was hoping someone may have some information regarding setting an auth/pass/pin code to dial an internal DN. This is required as we have a PA System for a warehouse, which we wish certain people to be able to dial to make announcements via the DN. We are using a Merdian 1 11c system (rel...

Hi, I was wondering if it was possible to delete an AC2 entry in option 11c. I have seen comments regarding using an "X" in ld 86, but have had no sucess. Any other ideas ? Cheers, Paul