Search results for query: *

Hello Guys I have very strange problem to setup very simple OSPF between 3 routers in hub-spoke scenario. Here is config from hub router in main office: interface ATM0/1/0 no ip address ip directed-broadcast ip pim sparse-mode no atm ilmi-keepalive ! interface ATM0/1/0.1 point-to-point ip...

Hello I think that I want to do something impossible but want to check with you guys. I need a directory number on CM 4.2 that will automaticaly play MOH. I tried to redirect to park number but this not worked. Any idea, suggestion ... P.S. I can't install CRA and IPCC for this

Hello I have configured new Unity connection 2.0 and have small problem. I.e when I call arrive and it is forwarded to the vm directly (at off-hours) caller hear Sorry before hear personal recording and I can't find way to remove this system recording. Any idea ?

Hello Is somone managed to install Unity on 2k3 server that is not cisco approved ? Any tip ? Thank you

Hello, I am having problem with VM MWI function. Problem is that when I dial MWI ON/OFF numbers I am getting busy signal and can't use MWIs. When I dial from the phone I am getting busy signal and lighs goes on/off but when this is done from 'real' VM system this doesn't work. ANy help is very...

Hi, I have on the c2811 router FXS and FXO ports - controlled via MGCP by CCM 4.1. I've assigned DNs to FXS ports - connected them to PBX and when user from legacy phones call this extension they receive dialing tone - and can further dial extensions on CCM. FXO ports are connected to PBX as...

Hello, I'm wondering is possible to pass # to other call manager? I have 2 CM-s and not so developed dialing plans.[My area is not covered by cisco :-(. I want that when users from one CM call number 123456# this should arrive to peer CM with same pattern. Right now it come as 123456. I want to...

Hello, I'm trying to connect 2811 as gateway with CCM via MGCP. I have 2 BRI and 4 FXO ports. I've added FXO ports and this work fine. But I can't find way how to add BRI ports for c2811 on call manager. Thanks Dulem

I'm trying to make lab environment for IPCC 6.0 and install all necesary components on one machine without lack. Is someone installed this on one machine. There is on cisco site lab guide for 5.0 version but not for 6.0. Thanks

Hi Guys, I'm trying to configure a Linux RH 7.3 server to act as router for policy based routing. Here is my problem. This server have to help me during IP migration. I'm in proces of moving IPs from one ISP to other and I want to keep all IPs (old and new) for a short time until DNS...

Hello, Are somebody configured 3DES tunnel between them?

I have 3640 router with BRI ports and 6 mica modems. ISDN call is accepted and everything work fine. Connecting via analog modem produce lot of following mesagess (debug modem output) May 27 14:43:40.491: Modem 1/2 Mica: in modem state SS_RETRAINING .May 27 14:43:49.319: Modem 1/2 Mica: in modem...

Hello. My network is connected to 3 ISP’s with one 2610. I use static routes. Problem is that I can from outside world ping just one serial interfece which is default route. I have some hosts with 3 secondary adresses and I can ping all tree addresses. By changing default route serial interface...