Search results for query: *

Anyone know if there is a way to clear the counters for the sh track command?

Hi, I was hoping you guys could assist me with a VPN question. I was wondering what is the best way to determine that a tunnel has reset due to failed communication with the remote? I usually do: #sh cryp isa sa det, but although this gives me the countdown timer, it doesn't tell me if it was a...

Hi all. My CCNP expires in September of 09 and although I am working on a complete career change, it will be a few years before I am done with the schooling necessary to make the jump. I was wondering if the rules are still that any one professional level exam will renew my NP, and if so, what...

I am hoping someone can give me a clue on where to look next. This is a 2610 connected directly (via crossover) to a cellular internet device. With the device set to offer the public cellular net assigned IP via DHCP, the router works fine. However, with the device set to offer a private IP, the...

Hi, I am hoping someone might be able to help with a small failover issue I am working with. I have a situation where I am using EVDO as a primary data circuit, with a wic1-am for a backup. Currently I am looking for a forgiving fail-over technique. Routing to a tunnel seems like an obvious...

I am wondering if anyone has seen this problem and how I might resolve it. I am setting up a config for telnet into a DB9 console on another type of device. The device works properly as I can connect to it through hyperterm ANSI 9600N81 and it looks fine. However when I telnet through my 4A/S, I...

I hope you guys can help me out with this!! I have a situation where I have an ethernet port on my router connected directly to another ethernet port on an adjacent satellite unit via a x-over cable. My static routing is basically this: 0.0.0.0 0.0.0.0 (IP of adjacent satellite unit) 0.0.0.0...

I have a quick question about PVC status on my Cisco routers. It seems that on our AT&T T1 interfaces, the subinterfaces will always show in an "active" state regardless if there is a router connected to the other end of the mapped DLCI. However, on out MCI or Sprint T1s, if there is no router...

Is there some method I could use to create an additional logical interface similar in function to a loopback interface? I have already used my loopback interface and have some higher level equipment routing to it. I have lower level equipment that I need to point to an interface that I can make...

Hello all! I am trying to work out a restoral configuration for some x25 xot calls from stub routers. What I really need is a second loopback interface so that an operator could shut it down manually in order to make a stub router's x25 xot route roll over to the next ip address configured in...