Search results for query: *

Calling out over E&M wink tie line. Far end sends ringing tone back, but the Definity hangs up with the classic two tone warble approximately 10 seconds after the last digit is dialed. I changed a lot of the answer supervision values to no avail. If I answer the phone on the other side then...

I have a tie line setup to another pbx (not Avaya). I am receiving *ANI*DNIS and that works fine INCOMING on my tie line. It is not, however, sending that information on an outgoing call. It simply sends the digits to dial. The feature I turned on on page two of the trunk group: Incoming...

Okay... my second question of the week. I have created a new signalling group. When I view the status I have Group ID: 4 Type: facility associated signaling Group State: out-of-service Primary d-channel link: Port: 01b1624 Level 3 State: manual-out-of-service Do I need to somehow...

Hello all! I'm in the midst of doing some non-standard stuff with our definity. I am going to create a tie line, full 24 channel T1. To get extensions to our other tie line we use UDPcode 221. My question is...I've got the steps for almost all of the rest of the equation EXCEPT the 221 part...

I have defined a group page for about 10 phones. The group page has been busy for two days... I can't seem to figure out how to release it or even tell what's going on. Any advice would be great! Sometimes I feel so helpless *grin* -Matt

Currently we use an adtran tsu 600 to multiplex a line. One of these goes to our router, one goes to the phone system (channels 13-24) Basic questions on the tn464f card... will this interface directly with the smartjack? I don't need the data channels anymore and eliminating the Adtran...

We are moving a remote proligix R6 system to a new building. They will primarily use a trunk to our building down the street for all calls. We are putting in some POTS lines at the new location for 911 and emergency calling if the link between us is broken. Is the TN747 the right card to use...

Hopefully this isn't too beginner a question. Definity G3R6 I need to add another digital circuit pack. What all do I need to do? shutdown system and install card or what? Heck I don't even think I know how to shut this thing down. Never had to add a card before. Thanks for any help! -Matt

Our former phone system admin retired so here I am trying my best. We have some old POTS lines coming in to the building for fax machines etc. and we'd like to move them to our switch. (a G3siR6) The phone company can send them to our switch, but how do I go about routing them there? I...