Search results for query: *

Can you run a cas t1 on a TN767E Board. or is this board only for PRI t1's Thanks

I understood that the C-lan Card could be used as a H-323 IP gateway. Is this Possible? How? thanks. If not is there an IP card that can be used as a H-323 gateway?

We currently own a couple of Definity systems. these systems had been under service contract with Avaya and we recently canceled the Service/Maintenance Contract with them. How would someone go about getting full admin rights to the systems. I would like to clear alarms and use other commands...

Can anyone other that Avaya upgrade a Definity system. I have a G1 and would like to upgrade to a new version that will give me ISDN PRI capablities. Pablo

Hello, I am getting a busy signal when I try to call into my Definity G1 PBX through the INAD number. I have displayed the Netcon port and one of them shows busy. I cannot busy and release the ports. Can anyone tell me how to reset the port without powering down the equipment. Thanks

Problem: Connect Two PBX's. PBX A is a Definity G3. PBX B is a Definity G1. PBX A has Two T1 Pri's to PSTN and are used for all incoming and outgoing Calls. The T1 are also used to Time the Switch. PBX B is at remote location and has a point to point T1 connected to PBX A. PBX B does not have a...

I have two Definity Switches connected via two T1 tie Lines with E&M signaling. The Main Definity switch is s G3 and has two Isdn pri lines to the PSTN. The second Definity switch is a G1 and has to go through the first switch for PSTN connectivity. I need to know how if I can send the calling...

Hello Everyone, I have set up a DMS-100 PRI on my Definity G3 switch. My CO says everything looks ok . they see the D-channel come up and they can pulse in 4 digit and ring an extension on my Definity. Here's the Problem, When I try to TAC into this trunk group using All I get is a busy signal...

Hello Everyone, I need some help installing a new Board (TN 767E) I have a T1 pri from our Telco which is a DMS-100 type ISDN. I need help in setting up the DS1 board settings. The setting I have doubt in are as follow: CONNECT: (network, pbx, line-side, host) COUNTRY PROTOCOL: (1,2,3,4,...)...