Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
IBM 7013-J40 fails to boot
Hi all, We have an IBM 7013-J40 that fails to boot. We attempted to bring up in normal mode one of the first messages we receive is " NO VALID FLASH FIRMWARE ! ". It attempts but fails to find a boot device and stops at " system unable to IPL". In SERVICE mode pretty much... -
FP_OPEN in errpt
Hi all, We are experiencing a continual message in the errpt only after bootup on our RS6000 AIX 4.3.3. Does not seem to effect performance however it is an error and we would like to understand it. Have looked all about the IBM sites with no luck. Thought we would ask here... Any thoughts... -
Comparing loads
Hi, I was wondering if anyone has an idea as to how one might compare the software load of one AIX machine to either, another machine or a flat file that list the required packages. I have run through the smit screens and have not found anything that would fit the bill. For an example, I have... -
Serial printer woes
Hi, I have been wrestling with a serial attached printer issue now for the past couple of days and am in desperate need of some new ideas. IBM 6F1 ( newly installed) AIX 4.3.3. 8 port asyn adpt IBM 6400 line printer We are able to print single and multiply small job however the printer... -
issue restoring a MKSYSB
We have a customer that had a failed hdisk0 (rootvg) on a AIX 4.3.3 system. IBM Hardware support reported cause of "Stickstion". This is now a new word in my vocabulary. Apparently, this is a known issue with old IBM 2 gig drives. Anyhow, a drive replacement and a simple MKSYSB restore... -
Entry to command line and output to screen hesitates
We just recently did a fresh install of SCO 5.0.5 on a HP Netserver LX Pro Dual 133 processors 256meg 2ghd HP10/100VG . After install we noticed that when entering commands a hesitation at the command line would intermittenly appear. The command entered would show after a short period say 2-3...- dietz
- Thread
- Replies: 7
- Forum: General UNIX discussion
-
How do I go about migrating 4.3.2 to 4.3.3?
The system is currently at 4.3.2 and we wish to migrate it to 4.3.3. Is this just a patch CD install_all or do we have to go the full gambit with all the Volumes?
