Search results for query: *

thread1329-1715972 FYI: I know I am adding a thread to old post but for what it's worth, I recently had this problem myself and was able to resolve it without replacing the phone by hard coding some of the network boot parameters into my 5330e phone by holding the # key down while powering up...

I administer several Mitel ICP systems and do new phone installs on all of them. I have run into a problem on our bigger phone system if I program a Mitel 5330 IP phone it will boot up immediately no hardcoding of any setting needed VLAN discovery all perfect. On the same phone system if I...

I have an older Mitel 3300 controller running level 6.x with a questionable 40 Gig IDE drive in it. Has anyone been successful at cloning a fully configured Mitel hard drive to a new drive and then getting it to boot?

Hello, just wondering if anyone has run into an issue with backup to disk failures. This has happened in the past and over time a matter of weeks seemed to resolve by itself and I was able to backup to my PC just fine. Here's what happens I make add / move or change and I am able to do a DBMS...

When trying to add new DNI circuit assignments I recieve the error above. E-Docs said: "The maximum space in the database for current release has been allocated; there is no more room to add new entries" I'm having difficulty determining what Lightware release I am running, is there any easy way...

Hi I'm setting up a DID number to route to an internal extension on our Mitel SX2000 - that was fairly easy to do. I am having problems with Nupoint voicemail picking up the unanswered calls. I've setup the voicemail box for the number of the DID and a callbox through the Nupoint Agent Callbox...

SUBNETRTR>sh ver Cisco Internetwork Operating System Software IOS (tm) C2600 Software (C2600-I-M), Version 12.2(8)T5, RELEASE SOFTWARE (fc1) TAC Support: http://www.cisco.com/tac Copyright (c) 1986-2002 by cisco Systems, Inc. Compiled Fri 21-Jun-02 08:50 by ccai Image text-base: 0x80008074...

HI, I've got a 2621XM IOS 12.02.8 and am having trouble configuring IPX routing. The router is supposed to support IPX routing from the product specs I've found but the commands for IPX do not appear as options. For example if I'm at the prompt router<config-if># (in ethernet 1) and type ipx ...