Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: pgatt62
  • Content: Threads
  • Order by date
  1. pgatt62

    Nortel Command Set Change?

    A customer has recently taken receipt of two new Nortel 5530-24tfd switches for back-up purposes and is having difficulty copying the running config of the live switch onto the new switches. The older original switch is firmware version 4.2.0.12 Software version v4.2.0.002 and the new switches...
  2. pgatt62

    Same-security-problems3

    Hi All I know that this is asking a lot but the config below from a ASA 5520 was hopefully meant to route between both inside secure networks and the outside world. It was also meant to redirect packets that were meant for remote networks connected to other WAN devices connected to the Data G0/1...
  3. pgatt62

    Same-security-traffic problems 2

    Hi All After appearing to have resolved my earlier problem I now find its back since i've put some extra configs on the ASA. I can get out to the net but cant ping my default gateway or the other inside interface. Anyone any ideas ? Regards etc pgatt62
  4. pgatt62

    Same-security-traffic problems

    Hello Again Following on from the flash worries, I've now installed the ASA and can access the internet from both G0/1 & G0/2 networks. My only problem is that I acn't ping across the device from hosts on each different network. I've enabled same-security-traffic and icmp inspect in the global...
  5. pgatt62

    Cisco ASA 5520 Flash Disaster

    It would seem that I have inadvertently deleted some flash from a new ASA 5520, namely the first flash 1841 IOS and some others. The ASA goes to ROMOMON first on boot then loads an IOS of some sort and at least lets some configuration take place but I do not know if it will operate under these...

Part and Inventory Search

Back
Top